HEYMIX K100 User manual

2-9KG
EACH
360°
360°
180°
360°
+90°
-45°
Adjustable instruction
E
1 : 2
①
①
4Cable management
As shown in the figure
Action 1: Squeeze the buckle inward.
Action 2: Place it into the hole site.
②
②
Adjust flexiblity
If you feel the pitching angle too tight or too loose
when adjusting the mount, please adjust the Screw
Press the arm to make it keep it in horizontal position and then use the Allen Key to adjust the screw on the arm.Turn
counter-clockwise(”+ ” direction) to increase gas spring tension till can hold the weight of your monitor.
Note: You may need to turn the screw by many circles to tighten the arm.
fall down
+
-
pop up
Case 1：Monitor/Arm fall down (after install your monitor)
Case 2：Monitor/Arm pops up (after install your monitor)
Press the arm to make it keep it in horizontal position and then use the Allen Key to adjust the screw on the arm.Turn
clockwise(”- ” direction) to reduce gas spring tension till can stay the position needed.
Note: You may need to turn the screw by many circles to tighten the arm.
K100
型号
6
5
7
G
G
G
32
9 8
Read the entire instruction manual before you start installation and assembly.
If you have any questions regarding any of the instructions or warnings,
Please contact your local distributor for assistance.
CAUTION:
Use with products heavier than the rated weights indicated may result in instability causing possible injury.
1. Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious
personal injury.
2. Safety gear and proper tools must be used. This product should only be installed by professionals.
3. Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware
and components.
4. Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
5. This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
6. This product is intended for indoor use only.Using this product outdoors could lead to product failure and personal injury.
IMPORTANT:
Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or
faulty, telephone your local distributor for a replacement.
MAINTENANCE:
Check that the bracket is secure and safe to use at regular intervals (at least every three months)
！
Turn clockwise to tighten
Turn counterclockwise to loose
+
-
MONITOR DESK MOUNT
INSTALLATION MANUAL

M5×10（×4） M4×10（×4）M6×10（×2）M8×16（×1） （×4） 4MM（×1） 5MM（×1）
A B C D E F G
Method 1
30-80mm
2
7
1
A
G
B
F
3
4
66
4
3
G
1（×1） 2（×1） 3（×1） 4（×1） 5（×1） 7（×1） 8（×1） 9（×1）6（×1）
B
F
1a-1 1b
3
1a-2a
1a-3
2
1a-2b
F
4
G
5
7
10-50mm
A
Method 2(desktop has a hole for item 2 go through)
G
C/D
Connect with monitor
Use a wrench (G) to screw the screws (C/D) into the four holes at the back of the monitor to avoid damaging the
moni-tor by over tightening the screws.
H
1 : 1
A
1 : 1
A
When the display is inserted into
the quick release head, make sure
the knob is vertical.
A
1 : 1
A
After insertion, rotate the knob
90 degrees to the left.