HHC WR114 User manual

WR114 Remote Control Instructions
1.Product Overview
Product Name：Remote Control
Product Model No.: WR114
2. Environment requirement
Operation temperature: +10℃~ +40℃.
Storage temperature: 10℃~65℃.
Operating Humidity：10%~80%RH，non-condensing.
Storage Humidity：10%~ 85%RH，non-condensing.
3. Directions for Operation
3.1 Pairing Remote
3.2 ADJUST:

3.3 ONE TOUCH BUTTON:

4. Matters needing attention：
4.1 The function will only work normally in proper working power conditions.
4.2 Remote Control needs three AAA batteries.
4.3 The control box is needed for proper control.
4.4 If problems are identified, they must be treated by professional personnel.
5. Additional attention for user：
5.1 This equipment has been tested and found tocomply with thelimits for aClass Bdigital
device, pursuant topart 15 ofthe FCC Rules. These limits aredesigned to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and canradiate radio frequency energy and, ifnot installed and used inaccordance with the
instructions, may cause harmful interference to radio communications. However, there isno
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio ortelevision reception, which can bedetermined byturning
the equipment off and on, the user is encouraged totrytocorrect the interference by one or
more ofthe following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into anoutlet ona circuit different from that towhich the receiver is
connected.
—Consult the dealer oranexperienced radio/ TV technician for help.
5.2 Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.