HIGH FORMAT BELVEDERE User manual

QUICK INSTALL GUIDE
BELVEDERE® FIRE PIT
Your safety is important to us. When appropriate, please follow OSHA guidelines and utilize safety
toe boots, hard hats and gloves, as well as eye, ear, and respiratory protection.
For more detailed information on the Belvedere® Fire Pit, visit our Technical Guide at www.
highformat.com or contact HIGH FORMAT® technical support.
Required:
·Level
TOOLS AND SUPPLIES
INSTALLATION TIPS
HIGHFORMAT.COM
[phone]
• Patio Top Installation: Fire pits should never be installed atop a patio surface. Rather, the re
pit should be “cut in” to the patio surface to avoid damage to the patio.
• Setting the Proper Circumference: Place the steel liner, lip-side down, at the point of
installation. Build the base layer around this liner to approximate proper circumference. Adjust
the circumference as necessary. Remember to ip the steel liner, lip-side up, after completing
the rst row of block.
• Pattern: Follow the attached block layout pattern to build the re pit.
• Securing the Coping: Adhere the coping to the top row of block with landscape adhesive.
• Ventilation Clearance: On the nished re pit, the steel liner should rest approximately ¼” below
the coping. This will allow for proper heat dispersal, extending the life of your re pit.
INSTALLATION NOTES
1. Familiarize yourself with the construction details shown in this document.
2. Mark out the location for your re pit. Note dimensions shown are nominal so mark an area
slightly larger than shown.
3. Excavate for drain stone base (approx. 6”)
4. Fill excavated area with drain stone, level, and compact.
5. Place and center steel ring on prepared base.
6. Place blocks per the pattern. (For Round Kit, keep Blocks 1 1/2” o steel ring)
7. WARNING! Do not place the re pit directly atop a patio surface. Instead, the re pit should be
“cut in” to the patio surface to avoid damage to the patio caused by conductive heat transfer.
8. After placing blocks around the ring, adjust the blocks in or out to make the circle close and t
tight. If the blocks do not close the circle, move all blocks slightly in. If the blocks seem too long,
move the blocks slightly out.
9. Place caps in circle around re pit. Adjust the caps in or out to make them t tightly together.
10. Note: Not suitable for large res. Fire size should not allow ame to contact Caps on Round
Fire Pit.
Gas conversion kits are available.
·Tape Measure ·Landscape Adhesive

HIGHFORMAT.COM
[phone]
INSTALLED PLAN VIEW
Finished
Dimensions: 58” Dia. x 14-1/2”H
TYPICAL INSTALLATION
A.
B.
C.
D.
Cap layer (three Cap Blocks shown for reference)
Belvedere® Fire Pit Blocks
14-gauge steel ring (37” dia. opening)
6” minimum drainstone base underneith
(See Block Pattern and Cross Section Detail for more information)
A
BD
C
BLOCK KEY
(Nominal Dimensions)
18x6 12x6 6x6 18x3 12x3 6x3 CAP
E
CROSS SECTION
(NO SCALE)
A
B
C
F
D
E
G
A.
B.
C.
D.
E.
F.
G.
Caps
Caps do not contact lip of steel ring
Belvedere® Fire Pit Blocks
14-gauge steel ring (37” dia. opening)
14-1/2” overall height
±2” gap
6” minimum drainstone base underneith
CROSS SECTION
BLOCK PATTERN ELEVATION
BELVEDERE® FIRE PIT DETAILS