HOMEbox XXL User manual

HOMEBOX XXL®
HOMEBOX XXL
Congratulations you now have an original Homebox XXL!
Before setting up the Homebox
1. Check all parts are there!
2. Read instructions carefully!
3. Do not equip before
set up is complete.
4. Assemble on a clean and flat
surface.
A x 1
B x 1
C x 2
D x 1

HOMEBOX XXL®
Assemble (3) and
(5) using the
plastic connectors.
The square edge
end of the
connectors must
be vertical!
Create frame like
shown left.
Put connector
onto poles.
square edge end
pointing
downwards!

HOMEBOX XXL®
Fit in poles (1)
; (6); (7)
and (8) into upper frame.
Lay out the tent bottom
(A) and
place frame carefully into
it.

HOMEBOX XXL®
Pull the tent top
(B)
carefully over the frame.
P
ay attention at the corn
ers!!!
Zip on
part
s
(C) to
Top (A) and Bottom (B).
TIP
!
Start with the top zips
first.

HOMEBOX XXL®
Add Bottom (D) and fix with Velcro.
Once you have zipped on part
s C (both are identical) your
Homebox XXL should look like this (see above)

HOMEBOX XXL®
Place
fi
xtures and straps
in
to
upper frame
as
shown above.
Repeat this process for both sides

HOMEBOX XXL®
We wish you a lot of success with your
HOMEBOX XXL.
If you have any queries please contact your local shop
or visit our website.
www.buy-the-homebox.com
Close all zippers carefully.
FINISHED!
Even though the Homebox has 2
waterproof floors make sure that the
area in which you set up your Homebox
is protected against possible tank leaks
or other types of water damage.
a. Passive air intakes -there are 2
possible ways, either you have
more air flow and thus also a bit
of light leaking or you tuck them
in between the first and second
flooring completely and thus
reduce the amount of air flow
and cut out light leaks.
b. The lower right hand opening can
be used for:
-active air intake (always make
sure that you outtake fan is
stronger than your intake fan)
-passive air intake (you can
regulate air flow and light leak by
adjusting the hole size with the
cords provided)
-External water reservoirs
-Additional cables