
7
PROGRAMMABLE HUMIDISTAT
The default humidistat setting is CO (continuous on). The programmable humidistat can be set in 5%
increments, from 35% to 55% humidity.
To program the humidity level, press the humidistat button. Then press the + or –button. The
humidity level will increase/decrease by 5% every time the + or –button is pressed and will show on the
display screen. Keep pressing the + or –button until the desired humidity setting is reached. The display
will show the set humidity level for 5 seconds, then default back to display the mist output level.
NOTE: To eliminate any programmed humidistat setting, press the humidistat button. Then press the
+ button until you reach “CO” (continuous on) one level above 55%.
NOTE: When the set humidity level is reached, the humidifier will cycle off until the humidity in the room
drops 5% below the set humidity level, then will cycle on until the set humidity level is reached again.
NIGHT-LIGHT/DISPLAY LIGHT
Press the night-light/display light button once to turn on the night-light. The light at the bottom
of the water tanks will turn on, illuminating the tanks. Press the night-light/display light button a
second time to leave the night-light on, but turn off the display light. Press the night-light/display light
button a third time to turn off the night-light and display light so no lights are illuminated. Press the
night-light/display light button a fourth time to turn the display light back on.
TIMER
Press the timer button. Keep pressing the timer button until the desired timer setting is lit on the
display. The timer button will cycle through the following settings: 2 hours, 4 hours, 8 hours, 12 hours.
To turn the timer off, press the timer button until 0 hours is shown on the display.
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
AUTO-OFF
When the water in the tank is almost empty, the humidifying function will power off.
NOTE: It is normal to have a small amount of water in the base during and after use.
ESSENTIAL OIL-CAPABLE
The optional essential oil feature will function automatically when the mist is turned on.
CLEAN TRANSDUCER/ULTRASONIC MEMBRANE
“CLEAN” will illuminate red after 120 hours of use, indicating it is time to clean the transducer/ultrasonic
membrane. See cleaning instructions in the Cleaning and Care section. After cleaning, press and hold
the power button for 3 seconds to reset the indicator.