Delay
The Deep Space consists of two identical
digital delay circuits that can be
configured in some interesting settings.
Both delays are controlled by their own
set of Mix, F.B. and Time knobs.
MIX is the volume control for each echo
circuit.
F.B. sets the amount of repeats.
Oscillating fun starts past 3 ‘o clock.
TIME controls the delay time of each
echo circuit. Instead of knobs, high quality
faders are used to set the delay time. Try
sweeping them up and down! Delay time
ranges from about 40 to 320ms.
is the knob that you can use to
rearrange the two circuits. All the way to
the left the delays are in parallel. Like
running two delay pedals next to each
other. All the way to the right the output
of Delay A is fed to the input of Delay B
creating a serial structure. Since this
control is a knob and not a switch, you
can also choose to use anything in
between parallel and serial.
TRANS Can set the amount of signal
being sent from Delay A to Delay B. This
one is interactive with the parallel/serial
knob.
Expression
An expression pedal input has been added
to the pedal to allow you to use your foot
to control the time on Delay A. Make sure
you turn off the pedal before connecting
an expression pedal.
____________________________________________
Footswitches
The Deep Space features true bypass
switching. To activate the effect, press the
BYPASS switch. If the green LED next to the
footswitch is lit, the signal goes through
the effect. If the LED is turned off, the
effect is bypassed. The LO-FI switch is
used to activate a very long delay time on
delay B. When the LO-FI switch is turned
on, the green LED next to that switch will
be lit. With the LO-FI switch engaged the
delay time ranges from about 650ms to 1s.