Hooker Furniture 3005-75005 User manual

1/2
ASSEMBLY INSTRUCTION
Item#: 3005-75005 Refectory Base-Dune
3005-75006 Refectory top-Drift
***Please make sure you have all parts indicated below prior to assembly.
This unit is heavy and can best be assembled with the help of two or more people.
HARDWARE LIST
E
D
F
GLOCK WASHER
1
12
12
12
H69*27.2*4mm ALLEN WRENCH
73*29*5mm ALLEN WRENCH
1
Q'TY
NO
50mm BOLT
FLAT WASHER
C
B
A
G
F
E
D
1. Place the top (A) upside down on a soft surface;
2. Attach the pedestal (B) to the top (A), align holes
on the pedestal and the top ,insert 1pc bolt (E) with
1pc lock washer (F) and 1pc flat washer (G) into
each hole; Don’t tighten them right now.(See
diagram 1)
3. Attach the other pedestal in the same way as step
2.
4. Place stretcher(C) onto two pedestals (B);
5. Insert 1pc bolt (E) with lock washer (F) and flat
washer (G) into holes in rail (C) and corresponding
holes in pedestal (B); (see diagram 2)
6. Tighten the bolts attached to stretcher(C) first with
allen wrench（D）.
7. Secure the bolts (E) attached to table top with
allen wrench (D);
8. Turn the table upright.
Diagram 1
Diagram 2

2/2
A
BC
A
BC
A
BC
H
You will adjust the bolts under the top when the leaves are not keeping level with the top, the steps
for adjusting the leaves lower and higher in order to keep it parallel with the top as below (See
diagram 6)
1. Loosen all of the bolts at the metal block.
2. Insert allen wrench (H) through the hole on to the head of the bolt on the “L” shaped metal
bracket.
3. Turn allen wrench (H) clockwise to raise the metal block, counter clockwise to low it, adjust it to
keep the leaves parallel with the top.
4. Tighten all bolts on the metal block.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and
water solution. Polish the finish with soft cloth and an industry recognized furniture polish.
Instruction for the leaves:
1. Pull out the leaves as the arrow direction
shown in diagram 3.
2. Lift the leaves up and make them 1/2”
higher than the center top.(See diagram 4)
3. Push and lay down the leaves as shown in
diagram 5.
4. There is a latch under both sides of the
leaf, unscrew the button by hand a little and
push it to the bottom of top, screw the
button tightly.
5. Before you put the leaves under the top,
please follow the reverse way of step 4 to
pull the latch back first.
Diagram 3
Diagram 5
Diagram 4
Diagram 6