Hooker Furniture 6960-75206-81 User manual

ASSEMBLY INSTRUCTION
ITEM# 6960-75206-81 60in Friendship Table w/2-12in Leaves
Caution: Please make sure you have all parts indicated below prior to assembly.
This table is heavy and can best be assembled with the help of two or more people.
Note:
1. Leaves cannot be switchable. Follow numbers on leaves and top when assemble.
2. Height of this table can be adjusted with or without extension blocks.
Assembly steps without extension blocks (30” height):
Diagram 1
1. Place table top (E) upside down on a soft surface to
prevent it from being scratched.
2. Place stretcher (F) onto top, make sure pre-drilled
holes on stretcher are aligned with holes on top. (See
Diagram 1)
3. Screw posts (G) through stretcher (F) to top by
turning in clockwise direction. (See diagram 2)
4. Place bases (H) onto posts and make sure all
pre-drilled holes are in alignment, well insert flat
washers (D), lock washers (C) and bolts (B), tighten
all with allen wrench (A). (See Diagram 3)
5. Turn desk upright.
Diagram 2
Diagram 3
1/3

Assembly steps with extension blocks (36” height):
Instruction for table leaves:
1. There are latches at the bottom of table top, turn off the latches as shown in Diagram 8.
2. Pull out table top as the arrow direction shown in Diagram 9.
3. Follow numbers on table leaves and top, place table leaves between and push table tops
together.
4. Turn on latches. (See Diagram 8)
5. Take opposite actions to remove table leaves.
Diagram 4
1. Place table top (E) upside down on a soft
surface to prevent it from being scratched.
2. Screw extension blocks (I) to top by turning with
clockwise direction. (See Diagram 4)
3. Place stretcher (F) onto extension blocks, make
sure all pre-drilled holes are aligned. (See
Diagram 5)
4. Screw posts (G) through stretcher (F) to
extension blocks (I) by turning in clockwise
direction. (See Diagram 6)
5. Attach bases (H) and follow the assembly step
4 of above without extension blocks indicated.
(See Diagram 7)
Diagram 5
Diagram 6
Diagram 7
2/3

Cleaning Instruction: Clean finished parts with a mild dishwashing liquid and water solution on a damp
cloth. Polish the finish with soft cloth and an industry recognized furniture polish.
Diagram 8 Diagram 9
3/3