
- The engine itself is not waterproof, please do not immerse it in water.
- Do not make the engine fall down, to avoid any damages.
- Check that the transmission’s screw of the drive shaft ts
well into the engine’s slit.
- Screw the drive shaft to the engine driver.
- Thread the drive shaft into the extension if you use one or simply connect
your hand piece to the Quickex connection of your drive shaft.
- Switch on your engine with the driver box & adjust your speed (we advise
working on the 3rd level). You are ready to work.
+ Engine
+ Belt
This rivet is dedicated to adjust the width of your belt
& avoid that the driver box slips down the belt during
the intervention (when pressing the buttons).
Press hard to x it.
Setting up
NB : Because the engines benets from an electronic clutch, we are proposing
EVOLUTION drive shafts without pins.
3/9