Hot Yoga Heating HYH-32-P User manual

1-844-yoga hot
(964-2468)
INSTALLATION MANUAL
HYH-32-P
UNIVERSAL THERMOSTAT

Thank you for choosing the HYH-32-P thermostat. The thermostat should be installed by a qualified
HVAC contractor or electrician. This manual contains wiring and setup functions for Hot Yoga
Studio Electric Radiant Heating Panels which, if not correctly performed, may cause damage to
the equipment or seriously affect performance.
Although the HYH-32-P is a universal thermostat that can be used with most HVAC equipment applications
Although great care has been taken in the preparation of this manual, Hot Yoga Heating takes no

INSTALLING THE THERMOSTAT
DISASSEMBLY
Insert a small coin (dime) in the release slot located
on the bottom of the thermostat. Gently twist the coin
to release the thermostat from the subbase. Avoid
twisting the case as this may stress the LCD or bend
the terminal connector pins. (Figure 1)
THERMOSTAT LOCATION
The thermostat should be installed in a location that
represents the ambient space temperature. Do not
install the thermostat in an area where drafts are
present, near the floor, behind doors or on an external
wall. Avoid placing the thermostat in areas where the
air movement is limited, affected by direct sunlight or
other areas not typical of the temperature in the
space.
MOUNTING THE SUBBASE
When mounting the thermostat, be aware that drafts
may travel down wall cavities and enter the back of
the thermostat through the control wire hole in the
wall. It is important to seal the hole to prevent any
drafts that might affect the internal temperature FIGURE 1
As with any HVAC project, careful installation is the key to a successful outcome. Time taken during
the installation process will be rewarded with fewer call-backs.
The steps required to install the HYH-32-P thermostat are as follows:
1. Read and understand this Installation Manual and Operation Manual.
2. Mount the Thermostat.
3. Set the 8 system switches to match the equipment application.
4. Wire the optional remote temperature sensor(s) or devices.
5. Power the thermostat.
6. Set the Advanced Installer Setup options.
7. Program and setup the thermostat. (Refer to the Operation
Manual for instructions)
8. Test heating, cooling and other functions.
GETTING STARTED
2

The thermostat contains a set of eight system switches located on

THERMOSTAT

THERMOSTAT

THERMOSTAT

The thermostat requires that the Advanced Installer Settings be changed for electric radiant heating.
To enter the Advanced Installer Settings menu, push the button once, then hold it down (15O/RIDE
seconds) until the LCD displays LC which is the first menu item. You can move forward or backwards
through the menu by pressing the or buttons. Use the up and down arrows to changeO/RIDE PROG
settings.
Set FN = H (Heat Only)

REMOTE SENSOR
A remote sensor can be wired to the T and T terminals on the thermostat and is typically used when
the thermostat is located outside the controlled space. When the remote sensor is used, Installer
Setting TT must be set to RS. Refer to Advanced Installer Settings Menu.

When the thermostat is powered, the LCD will briefly show all the available LCD icons, software version,
Recovery function of the thermostat permits the user to program a time that a desired set temperature is

1-844-yoga hot
(964-2468)
06-1300-050718