Howard SLS008 Series Service manual

INSTALLATION INSTRUCTIONS
For models:
SLS008xxxx; SLS020xxxx; SLS030xxxx
1
SLS - Solar LED
Streetlight
2018-04-19
WARNING
Please read instructions carefully before attempting to
install fixture, and retain instructions for future reference.
FIXTURE INSTALLATION
Note: To avoid over-discharge of battery, allow
the luminaire to fully charge before commis-
sioning.
1. Attach the adjustable fitter (T-40 torx security)
to the luminaire, and adjust to appropriate an-
gle for the installation latitude. (A minimum of
15° from horizontal is required for self-
cleaning.)
2. Adjust the LED array (phillips) to compensate
for the tilt of the luminaire. LED array should
point directly down.
3. Insert the mounting arm into the fitter and level
the LED array. Securely tighten the fitter to the
mounting arm (T40 torx security).
4. Actuate the switch located on the bottom of the
luminaire and confirm that the battery is fully
charged (solid red LED in motion sensor).
5. Cover the solar panel with and opaque materi-
al. The luminaire should turn on within a mi-
nute.
6. Program the luminaire via the wireless remote.
Power Switch Sensor LED Array
Charge Condition
Indicator Charging Port
(16VDC 5A MAX)
Color State Condition
RED Solid Fully Charged
RED Slow Flash Charging
RED Fast Flash Charging Fault
GREEN Solid State of Charge >10%
GREEN Slow Flash State of Charge <10%
Charge Condition Indicator

INSTALLATION INSTRUCTIONS
For models:
SLS008xxxx; SLS020xxxx; SLS030xxxx
2
SLS - Solar LED
Streetlight
2018-04-19
Programming with the wireless remote
Disable
Unit Test
Motion Sensing Modes:
Time Based Modes:
Constant Output Modes:
NOTE: The Luminaire will
flash twice when mode
selection is received.
NOTE: The Luminaire
will reduce to half power
when battery is less
than 40% charged.