Howard XALE-C300-HV Series Service manual

INSTALLATION INSTRUCTIONS
XALE Series
04/12/2018
Doc#1025-000244-000 RV0
Model number parameter list
1Where Crepresents CCT variations.
Model1
Input Voltage
Input Power
(W)
Power
Factor
Input
Current
Weight
(lbs)
Ambient rating
XALE-C100-MV Series
100 –277VAC
50/60 Hz
100W
>0.9
1.5A
19.5
-40° to +40°C
-40° to 104°F
XALE-C150-MV Series
150W
1.8A
19.5
XALE-C230-MV Series
230W
2.5A
23
XALE-C300-MV Series
300W
3.5A
29.5
XALE-C100-HV Series
277 –480VAC
50/60 Hz
100W
0.55A
19.5
XALE-C150-HV Series
150W
0.88A
19.5
XALE-C230-HV Series
230W
1.4A
23
XALE-C300-HV Series
300W
1.8A
29.5
Warning:
To avoid electric shock:
Be certain electrical power is OFF before and
during installation and maintenance.
Luminaire must be connected to a wiring system
with an equipment-grounding conductor.
Warning:
To avoid the risk of fire, explosion, or electric shock, this
product should be installed, inspected, and maintained by a
qualified electrician only, in accordance with all applicable
electrical codes.
Warning:
Make sure the supply voltage is the same as the
rated luminaire voltage.
Not suitable for hazardous location use.
Do not operate in ambient temperatures above
those indicated on the luminaire nameplate.
Keep lens tightly closed when in operation.
For supply connections use wire rated for at least 90°C (194°F)
Mounting Details (inches):
Mount Arm
Mounting hole guide
Pole-side nuts/bolts
Arm-door screw
Fixture-side bolts

INSTALLATION INSTRUCTIONS
XALE Series
04/12/2018
Doc#1025-000244-000 RV0
Installation Steps
1. Release arm-door screw (1 screw) to gain access to wiring compartment and pole-side nuts/bolts.
2. Mount arm to pole with supplied hardware. Ensure that it is tight, secure, and gasket is in place. (requires Metric #14
wrench)
3. Attach luminaire to the arm using supplied hardware. Transfer fixture wire inside the wiring compartment.
4. Ensure power is off, and then make electrical connections. Connect wires; white wire to “Neutral”, black wire to “Line”,
green wire to “Ground”.
5. Check that the lighting fixture is firmly installed and wired correctly.
6. Close the arm-door.
7. Finally, turn on power and verify function.
Mounting on round poles:
Use XAL-RPA accessory to mount this fixture on round poles, up to 5” diameter (sold separately)
Additional Product Images# 1025-000230-050 RV00
100W, 150W Luminaire
230W Luminaire
300W Luminaire