HP 7 Plus G2 User manual

User Manual
Model: HSTNH-B407D

Product Overview

Micro USB 2.0 HS Earphone 3.5mm Slot
Front-Camera Power Key
Volume Key + Volume Key-
Micro SD Slot SIM Card Slot
Speaker Rear-Camera

Getting Started
Turning the tablet On/Off
To turn On the tablet
1. Press and hold the PWR key for a few seconds.
2. Unlock the screen with your finger.
To turn Off the tablet
1. Press and hold the PWR key, select Power Off;
2. Tap OK. The tablet will be off in a few seconds.
Unlocking screen
The screen is locked by default when you turn on the tablet. To unlock the screen,
1. Press the PWR key.
2. Drag the inner ring to the edge of the circle to unlock the screen. Draw a pattern if the screen is protected by
pattern lock. Enter a PIN or a password if the screen is locked by a PIN or a password.

➠
Locking screen
To lock the screen, press the PWR key. It is recommended to lock the screen to protect information in the
tablet and reduce battery usage.
You can also configure your tablet to automatically lock after a certain period of time.Tap
→Settings→Display→Sleep to set the sleep time from 15 seconds, 30 seconds, 1 minute, 2 minutes, 5
minutes, 10 minutes, or 30 minutes.
Using touch screen
All of the functions of the tablet, except for power and volume, are performed on the touch screen. Therefore, it is
essential to know how to use the touch screen.
The following finger actions might help you easily understand how to use the touch screen.
Tap: Touch an item (e.g. application or widget) once that appears on the screen with your finger to run it or
access a menu or an option
Double tap: Tap an item twice with your finger
Drag: Tap and hold your finger on an item and move it without losing contact with the screen
Flick: Place a finger on an empty space of the screen and move the screen up or down, or left or right
Pinch: Place two fingers on the screen and move them apart to zoom in a picture, a document or a web page,
or move them together to zoom out
Select and tap: Tap an item in the list of options available
Press and hold: Press a key or any item for a few seconds until a list of options appears
Cautions:
Do not use sharp tools that can scratch the touch screen.
Do not allow the touch screen to come in contact with chemicals. The screen may malfunction in chemicals.
Do not sit on the tablet: the touch screen can be damaged.
Status bar
The status bar at the top of the screen notifications from various apps, time, and the states of various devices
such as battery status, WIFI status, Signal status and so on.

1. Notification panel displays notification icons to inform you of new Email, messages, and so on. Slide the
panel down to view the notifications and then tap a notification icon to view details of the notification.
2. Status panel displays status icons to show the current state of your tablet, such as battery charging progress,
alarms, Bluetooth, and so on. Slide the panel down to access more settings and configuration options
Screen orientation
For optimal viewing experience, the screen orientation changes automatically depending on how you hold
the tablet.
NOTE: To enable or disable auto-rotate, slide down the status panel and tap the Auto-rotate icon.
Keys and functions
1. Back key
Tap to return to the previous screen and exit the running application.
Tap to close the on-screen keyboard in text input mode.
2. Home key
Tap to return to the main screen.
Tap and hold to open the Google search.

3. Menu key
Tap to open the applications list used recently.
Apps and widgets
Apps: Software that allows you to perform aspecific task. Your tablet is preloaded with avariety of
applications, and additional applications can be downloaded from the Play Store.
Widgets: Asmall application which resides on the home screen and provides quick and easy access to
information.

Connecting to the Internet using WiFi
NOTE: The range and quality of the WIFI signal is affected by the distance between the tablet and the
wireless router,the number of connected devices, infrastructure, and objects through which the signal
is transmitted.
1. Tap →Settings→WIRELESS & NETWORKS→WIFI.
2. Enable WIFI by moving the slider to On position. The tablet scans for WIFI networks in range.
3. Tap the network you want to connect to.
4. Type a password (if connecting to a secure network) and tap Connect to connect to the selected WIFI
network.
NOTE: To connect to a secured WIFI network, you must provide the security key. If you do not have
the security key, contact the person who manages your WIFI network or the router manufacturer.
NOTE: To start a new search for available WIFI networks, on the WIFI screen, tap →Scan

Connecting to the Internet using mobile broadband
1. Tap →Settings→WIRELESS & NETWORKS→WIFI, then touch WIFI to disable it.
2. The tablet automatically searches for the carrier signal and connects to the network. When the tablet
is connected to a mobile broadband network, the network type appears in the status bar.
NOTE: Make sure you have a valid SIM/USIM IN the tablet
On the mobile broadband model, if both WIFI and mobile broadband networks are available, the
tablet gives priority to WIFI connection.

Safety Information
The following list shows how to maintain your tablet, together with precautions to take.
Keep your tablet and its accessories out of the reach of pets.
Do not allow children to use your tablet. If children use the device, make sure that they use the tablet
properly.
Maintain your tablet in dry conditions and keep it within normal operating temperatures. Temperatures
higher than 55°C (131°F) or lower than -20°C (-4°F) may damage your tablet.
Do not try to dry your tablet in a microwave oven. If you do, sparks can occur and cause an explosion or fire.
Do not use or store your tablet in dusty or dirty areas.
Do not attempt to disassemble your tablet.
Do not drop or cause severe impact to your tablet.
Do not use chemical products, cleaning solvents or detergents to clean your tablet.
If your tablet does not work properly, contact your dealer immediately.
Use only authorized batteries, battery chargers and accessories. Any malfunction or damage caused by the
use of unauthorized batteries, battery chargers and accessories will void the limited product warranty.
Ensure that the battery charger does not come in contact with conductive objects.

CEMarking
ThisdevicehasbeentestedtoandconformstotheregulatoryrequirementsoftheEuropeanUnion
andhasattainedCEMarking.TheCEMarkisaconformitymarkingconsistingoftheletters“CE”.The
CEMarkappliestoproductsregulatedbycertainEuropeanhealth,safetyandenvironmental
protectionlegislation.TheCEMarkisobligatoryforproductsitappliesto:themanufactureraffixesthe
markinginordertobeallowedtosellhisproductintheEuropeanmarket.
ThisproductconformstotheessentialrequirementsoftheR&TTEdirective1999/5/ECinorderto
attainCEMarking.Anotifiedbodyhasdeterminedthatthisdevicehasproperlydemonstratedthatthe
requirementsofthedirectivehavebeenmetandhasissuedafavorablecertificateofexpertopinion.
Assuchthedevicewillbearthenotifiedbodynumber0560aftertheCEmark.
TheCEMarkingisnotaqualitymark.Foremost,itreferstothesafetyratherthantothequalityofa
product.
Secondly,CEMarkingismandatoryfortheproductitappliesto,whereasmostqualitymarkingsare
voluntary.


FederalCommunicationsCommission(FCC)Statement
15.21
Youarecautionedthatchangesormodificationsnotexpresslyapprovedbythepartresponsiblefor
compliancecouldvoidtheuser’sauthoritytooperatetheequipment.
15.105(b)
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuant
topart15oftheFCCrules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmful
interferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcanradiateradiofrequency
energyand,ifnotinstalledandusedinaccordancewiththeinstructions,maycauseharmfulinterference
toradiocommunications.However,thereisnoguaranteethatinterferencewillnotoccurinaparticular
installation.Ifthisequipmentdoescauseharmfulinterferencetoradioortelevisionreception,whichcan
bedeterminedbyturningtheequipmentoffandon,theuserisencouragedtotrytocorrectthe
interferencebyoneormoreofthefollowingmeasures:
‐Reorientorrelocatethereceivingantenna.
‐Increasetheseparationbetweentheequipmentandreceiver.
‐Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
‐Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
ThisdevicecomplieswithPart15oftheFCCRules.
Operationissubjecttothefollowingtwoconditions:
1)thisdevicemaynotcauseharmfulinterferenceand
2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesired
operationofthedevice.
FCCRFRadiationExposureStatement:
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforanuncontrolledenvironment.
EndusersmustfollowthespecificoperatinginstructionsforsatisfyingRFexposurecompliance.
Thistransmittermustnotbeco‐locatedoroperatinginconjunctionwithanyotherantennaor
transmitter.

SAR Information
FCC: 1.35 W/Kg @ 1g
