Product specifications subject to change without notice
High Point Furniture Industries • 1104 Bedford Street • High Point, NC 27263 • t 800.447.3462 • f 800.231.6784 • www.hpfi.com
PowerFlex™
Innovative Power + Data Solutions 6
Appendix
Specifications
Power Requirement: 120 VAC, 12A
Certification: ETL Certified
Weight: 25 pounds
Measurements: 25.50” tall x 18.00” at the widest point
9 Tamper Resistant receptacles
6 Active USB charging ports.
9’ Power cord.
Circuit breaker for overload protection.
No-Slip rubber feet provide 0.75” floor clearance.
Magnetic catch secures cord when not in use.
Recesses in base allow Tripod to be tucked up close with floor boxes
when plugged in.
Slots in the base allow unit to be tethered to the floor or a pole if sta-
tionary application is desired.
Tri-core design allows for 360 degree power access.
3
PowerFlex™
Innovative Power + Data Solutions
High Point Furniture Industries • 1104 Bedford Street • High Point, NC 27263 • t 800.447.3462 • f 800.231.6784 • www.hpfi.com
Product specifications subject to change without notice
Introduction
Congratulations on your purchase of the HPFI PowerFlex Tripod. This
product is ideal for any environment where competition for traditional
wall power outlets is a challenge.
Who We Are
High Point Furniture Industries was founded in 1958 and remains a pri-
vately held, veteran-owned business. The first products were novelty
furniture items for the home (TV stands, record cabinets). High Point
entered the office furniture market in 1963 with the introduction of the
first budget-priced wood desk, 100 Series. Up to that point, low-cost
desks were made primarily of metal; wood desks were significantly more
expensive. Today, our operations include two manufacturing facilities
with over 440,000 sq. ft. in High Point, NC where we produce 19 different
series of veneer and laminate casegoods and over 60 series of reception,
office and healthcare seating products.
Product Overview
The Tripod incorporates nine-120v 15 Amp tamper resistant power recep-
tacles and six low voltage, (5 Volt DC), active USB ports. Capable of being
relocated at will, the six rubber feet prevent sliding and provide clearance
and stability on uneven surfaces or over floor boxes. In the event you
would like the unit applied in a more permanent setting, mount or tether
points are accessible on the bottom of the unit. When the Tripod is not in
use the cord stores seamlessly in the base and is held in place by the
magnetic catch.
