Huawei EM772 User manual

Copyright © 2009 Huawei Technologies Co., Ltd.
All Rights Reserved
No part of this document may be reproduced or transmitted in any form or by any
means without prior written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
and other Huawei trademarks are trademarks of Huawei Technologies Co.,
Ltd.
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
Notice
The information in this document is subject to change without notice. Every effort
has been made in the preparation of this document to ensure accuracy of the
contents, but all statements, information, and recommendations in this document
do not constitute the warranty of any kind, express or implied.

Table of Contents
Getting to Know the EM772............................................................. 1
Requirements for the PC................................................................. 2
Preparing the EM772...................................................................... 3
Installation Guide .......................................................................... 4
Safety Information........................................................................10
i

Thank you for purchasing Huawei EM772 HSPA/Wi-Fi
Module.
Note:
This manual briefly describes the preparation, the process for
installing/uninstalling, and safety precautions for using Huawei EM772
HSPA/Wi-Fi Module (hereinafter referred to as the EM772).
You are recommended to read the manual before using the EM772.
The signal strength and the transmission rate are affected by the actual
environment.
Getting to Know the EM772
The following figure shows the appearance of the EM772. The actual product may
differ.
1
3
2
2
1

Mini PCI Express connector
It is used to connect the EM772 to the WWAN Mini PCI Express interface of the PC.
Screw holes
They are used to fix the EM772 on the main board of the PC with screws.
Antenna interfaces
They are used to connect antennas.
EM772 has an external antenna which connect with laptop.
The max gain which is allowed of external antenna is ：
900M:<2.1dBi
1800M:<2.6dBi
2100M:<4.3dBi
850M:<4.28dBi
1900M:<3.6dBi
Requirements for the PC
To use the EM772, the PC must meet the following requirements:
WWAN Mini PCI Express interface.
Windows 2000 SP4, Windows XP SP2, Windows Vista and Linux 2.6.18 or
above
The hardware of your PC must meet or exceed the recommended system
requirements for the installed version of OS.
Display resolution: 800 × 600 or above.
2

Preparing the EM772
Locate the WWAN Mini PCI Express interface on the main board of the PC. Find the
main antenna and the auxiliary antenna.
If a USIM/SIM card is provided by your service provider, insert the USIM/SIM card
into the USIM/SIM card slot on the main board of the PC.
Note:
In certain cases, your PC may be disassembled only by the professionals.
Before you install the EM772 onto the main board of the PC, consult the PC
manufacturer or read the user manual of the PC.
3

Installation Guide
Installing the EM772 onto the Main Board of the PC
1. Insert the Mini PCI Express connector of the EM772 into the WWAN Mini PCI
Express interface on the main board of the PC.
2. Press downwards to fix the EM772 in the module slot.
4

3. Use a screwdriver to fix the EM772 onto the main board of the PC with two
screws provided in the EM772 packing box.
4. Insert the connector of the main antenna into the MAIN antenna interface (M)
of the EM772 according to the indication on the label of the EM772. Insert the
connector of the auxiliary antenna into the AUX antenna interface (A) of the
EM772 in the same way.
Note:
Insert the antenna connectors vertically into the antenna interfaces of the
EM772.
5

Do not pinch the antenna cable or damage the connectors. Otherwise, the
wireless performance of the EM772 may be reduced or the EM772 cannot
work normally.
Ensure that the antenna cables are routed through the channel in the frame of
the PC and do not lay across the raised edges of the frame.
6

Removing the EM772 from the Main Board of the PC
1. Disconnect the antenna cables from the EM772. You can lift the connectors
with a small screwdriver.
2. Remove the two screws with the screwdriver.
7

3. Slide backwards the two clips to release the EM772 from the slot. Then, lift up
the EM772.
Installing the EM772 Software
A disk is provided in the EM772 packing box. The disk contains the management
program and the driver of the EM772.
1. Insert the disk into the disk drive of the PC.
2. Find the AutoRun.exe file under the disk path. Then double-click
AutoRun.exe to run the program.
3. Follow the prompts of the installation wizard.
4. After the program is installed, the shortcut icon of the management program
is displayed on the desktop.
Uninstalling the Management Program
1. Choose Start > Control Panel.
2. Find the management program, and click Add/Remove Program to
uninstall the management program.
8