Hunza SAFETOUCH 50 LED User manual

SAFETOUCH 50 LED
INSTALLATION INSTRUCTIONS
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR
LOCAL ELECTRICAL AUTHORITY REGULATIONS, WITH WHICH
ALL INSTRUCTIONS HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Remove the complete xture from the packaging. If the canister and
luminaire are to be installed separately detach the luminaire from the
canister and place it back in the packaging and store securely.
If not discard the packing in an environmentally friendly way.
Dig a hole 20cm (8”) diameter and 30cm (12”). Place drainage material
in the bottom of the hole to drain away water and stop water level
build up. (See Fig. 1).
Sit mounting canister into the hole. Make sure that the top of the
canister is ush and level with the nished oor or ground level
(see Fig. 2).
Draw the power supply cable up through the centre of the canister
ready for connection to the luminaire.
Place blue ange protector into the top of the canister and press rmly
into place. This will protect the bronze or stainless steel ange as well
as stopping debris lling the canister. If grout is to be used with tiles
etc. then remove the ange protector before grouting is started.
NOTE: Do not backfill with stones, scoria or any material that will
leave air gaps next to the canister.
Concrete is strongly recommended to backfill the canister hole.
Concrete will conduct away 40% more heat than soil.
Fig. 2
Fig. 1
For Direct bury. Make a waterproof connection with the Input and
dimming cables. (See Fig.3a)
Place the luminaire into the hole. Make sure the ange is ush with the
ground level and then back ll around the luminaire. Compact the
surrounding substrate to ensure good heat conductivity. Place
drainage material in the bottom of the hole to drain away water and
stop water level build up.(see Fig. 2a).
Fig. 2a

Once ground works are complete remove the blue ange protector.
Draw supply cable through canister and make a waterproof connection
to the luminaire input and dimming cables.
(See Fig.3a)
Place the luminaire into the canister. Make sure ange surfaces are
clean - dirt sand and mud free.
Tighten the two screws (A) provided that hold the luminaire into the
canister by hand only – no power tools should be used on this
luminaire. (See Fig. 4).
Make sure debris do not fall into the open luminaire while working.
Be certain to clean gasket recess before placing Lens and Gasket
assembly into the gasket recess in the luminaire (see Fig. 4a).
Make sure that the lens and gasket are clean.
Place Flange on top of gasket and lens assembly and tighten the three
screws (B) evenly by hand. (See Fig. 4a).
Fig.3
Fig.3a
Fig. 4
A
Fig. 4a
B
When wiring in SERIES (no driver integrated into fixture) no
dimming cable will be provided. Make waterproof connection with
input cable. DO NOT wire SERIES spec fixtures in parallel. The
power requirements of each SERIES fixture are: 6VDC @ 2000mA
SERIES WIRING
NOTE: Where dimming is required, cut and strip dimming cable to
make connection
DO NOT water blast/jet wash this xture under any circumstances.