• Start the product according to the
instructions. When the main switch is set
to 1; make sure to keep your hands and
feet away from the rotating blades. Never
put your hands and feet under the
product.
• Never touch moving hazardous parts,
such as the blade disc, before it has
come to a complete stop.
• Never lift up the product or carry it around
when the main switch is in position 1.
• The product must never be allowed to
collide with persons or other living
creatures. If a person or other living
creature comes in the product’s way it
shall be stopped immediately.
• Do not put anything on top of the product
or its charging station.
• Do not allow the product to be used with a
defective guard, blade disc or body.
Neither should it be used with defective
blades, screws, nuts or cables. Never
connect a damaged cable, or touch a
damaged cable before it is disconnected
from the supply.
• Do not use the product if the main switch
does not work.
• Always switch off the product using the
main switch when the product is not in
use. The product can only start when the
main switch is set to 1 and the correct PIN
code has been entered.
• The product must never be used at the
same time as a sprinkler. Use the
Schedule
function so the product and
sprinkler never run simultaneously.
• Husqvarna does not guarantee full
compatibility between the product and
other types of wireless systems such as
remote controls, radio transmitters,
hearing loops, underground electric
animal fencing or similar.
• The built-in alarm is very loud. Be careful,
especially if the product is handled
indoors.
• Metal objects in the ground (for example
reinforced concrete or anti-mole nets) can
result in a stoppage. The metal objects
can cause interference with the loop
signal which then can lead to a stoppage.
• Operation and storage temperature is
0-50 °C / 32-122 °F. Temperature range
for charging is 0-45 °C / 32-113 °F. Too
high temperatures might cause damage
to the product.
2.3 Battery safety
WARNING: Lithium-ion batteries
can explode or cause fire if
disassembled, short-circuited,
exposed to water, fire, or high
temperatures. Handle carefully, do
not dismantle, open the battery or
use any type of electrical/
mechanical abuse. Avoid storage in
direct sunlight.
For more information about the battery, refer
to
Battery on page 15
3 Installation
3.1 Connecting the power supply
Take the following into consideration when
planning where to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
1352 - 001 - 09.12.2019 Installation - 9
