Hyco Zen Ice Solo User manual

Product Installation Guide
Zen Ice Solo
Contents
The required hole diameter is 32 mm. Can be installed onto a sink/ countertop up to 50 mm thick.
Distance between centres - tap base to spout is 140 mm. Ensure this meets installation requirements.
Product code: ICESOLO v19.11.2
The o- ring sits in a groove on the underside of the
tap and is to be positioned on top of the mounting
surface, the metal washer and retaining nut go on
the underside.
Insert the grey ¼” to ¼” push t connector onto
the stem of the tap until a full stop is reached, pull
back the tting to test for a solid connection and
then insert the locking collar to prevent future
inadvertent removal.
1 2
Installation Steps
Provides ltered cold (ambient) water when connected directly to the mains supply.
Provides ltered cold (chilled) water when installed with an undersink chiller (supplied separately).

Make a connection to the incoming cold-water
supply using the brass compression tting.
Attach the plastic ½”BSP to ¼”push t connector by
screwing onto the brass tting.
3 4
With a sharp knife, cut the ¼”tubing (ensure a
straight cut and avoid crushing the tubing) to the
required length for connection to the lter head “In”
side.
Push the tube rmly into each tting (pull gently to
conrm good connection) and insert locking collar
(ensure no kinks in the tubing).
5 6
Calculate and cut the remaining section of ¼” tubing and make the nal connections between ttings as per
step 2.
7
01924 225 200hyco.co.uk
Supplied drinking water lter must be changed every 6 months or when the rated capacity is reached, whichever comes rst.
The tap is covered by a standard parts or replacement warranty for a period of 2 years from the date of purchase.
If you experience a problem with this product you should rst contact our service department on 01924 225 200 before taking
any further action. Experience has shown that issues can often be resolved without the need to return or uninstall the product.