
DIMENSION LED Luminaire
IndustrialLED Parking Garage Canopy Lighting
(Vega Series)
Features
• UL&CUL No E483348 Suitable for Wet Locations
• IP65 Rated Ingress Protection
BEFORE YOU INSTALL
Read these instructions completely and carefully.
ATTENTION
WARNING/ADVERTISEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
• Follow all NEC and local codes.
• Use only UL or IEC approved wire for input/output connections.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense.
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Electrical Requirements
The LED driver must be supplied with 100-277
VAC, 50/60 Hz per product label and connected
to an individual properly grounded branch circuit,
protected by a 15 or 20 ampere circuit breaker.
Grounding Instructions
The grounding and bonding of the overall system
shall be done in accordance with National Electric
Code (NEC) Article 600 and local codes.
Prepare Electrical Wiring
ILLUMINATION FIGURE
Announcements:
1.This equipment is only for professional installation. Non-professional personnel shall not remove or install the
equipment.
2.Please read the instruction manual before installation and keep it for future reference.
3.To avoid damage, falling, electric shock or fire, please do not modify the lamp or replace accessories without
confirming with the supplier.
4.Maintenance/installation and replacement the lamps , please confirm to cut off the power supply, and the lamps
have set up a cooling. Please make sure the lamps and has been properly installed before processing power.
5.Ensure the accurate and reliable connection.
6.Ensure that the product around the vent, the lamp cannot violate any fire prevention regulations when using.
*Please connect the input wire in correct way,
white is ACN, black is ACL, GREEN is ground
connection.
*Please also make sure the wire connection is
fixed perfectly before using.
Web: www.hi-hyperlite.com Email: info@hi-hyperlite.com Tel: + 1 (855) 688 7879 Web: www.hi-hyperlite.com Email: info@hi-hyperlite.com Tel: + 1 (855) 688 7879
CES-LS-VG-45W/65W
INSTALLATION
- Surface Ceiling Mounting - Piping Mounting
73.5mm
[2.9"]
230mm
[9.1"]
3/4inch 1/2inch Reducer
P3P2