HYUNDAI WELDING HiEGW 600W User manual

HEAD OFFICE : ILSONG BLDG. 16th fl.157-37,
SAMSUNG-DONG, KANGNAM-KU, SEOUL, KOREA
TEL : [phone] FAX: [phone]～
FACTORY : 9-2, SAEUM-DONG, ICHEON-SI, GYEONGGI-DO, KOREA
TEL : [phone] FAX: [phone]
Visit our website at
www.HDWELD.co.kr
www.hyundaiwelding.com

Φ
Use this welding power source at or under the rated duty cycle
Exceeding the rated duty cycle limitation may result in damage to the
welding machine.
The duty cycle is the percentage of a ten minute period that a welding power source can be•
operated at a given output without causing overheating and damaging the unit.
The rated cycle of the welding power source is the following :•

2. Welding cables, the coverings of which are not capable of withstanding a
conductor temperature of 85 , will be damaged if the coupling devices
are used at the rating given above at an ambient air temperature of
40 .

Connection observes and handle wiring in below.
1) Connect the power cable for base metal between the "Base metal (-)" terminal and
the base metal.
2) Attach the power cable for wire feeder to the "Wire feeder (+)" output terminal.
3) Insert the control cable for wire feeder into the socket for wire feeder.
4) Attach the gas hose to the gas outlet on the wire feeder.
5) Connect the welding torch to the wire feeder.

Φ

Connecting Input Power must meet all National and Local Codes - have only qualified•
persons make this connecting.
Before connecting input power, See rating label on unit and check input voltage available at•
site.