IAT IAT-HDMI/VGA/CVBS-H.264 mini decoder User manual
1080P H.264 HDMI VGA CVBS Video Decoder
HTTP RTSP UDP strea ing receiver
User Manual
Model: IAT-HDMI/VGA/CVBS-H.264 ini decoder
ia-tecs@hotmail.com www.iat101.com www.peephole-store.com
www.ezdiybroadcast.com
Input
admin
admin
1. Connecting to internet router, power on, and then open WEB UI (user interface from a PC
If your PC default IP address is not in 192.168.1.*, Please check appendix I for how to change
the IP address
2. Open Google (or IE and input 192.168.1.169, and use admin for both user name and
password
Check current Decoder status
Address Settings
You can buy several decoders, and set the channel up to 4 channels
Network Settings
Check IP address. In case you changed and forgot the IP address, you may press the reset
button (located at front panel for 15 sec for resetting to default setting.
Decoder Output Settings
Note: Please remember to click “ Reboot” every time you make a modification
Reboot Syste
Reset Syste
Only when you want to set your system back to factory’s default setting, you press reset
The system or use a clip press the decoder’s reset button for 10 seconds as the hardware reset
Appendix I: How to change co puter IP address to 192.168.1.*
Go to control panel and find “ Network and Internet”
Change adapter settings
Click properties
Click Internet Protocol version 4 (TCP/PV4
Check if current IP is 192.168.1.*? If it is not …please change it as following
Note: You may change the decoder’s IP to 192.168.0.* if you prefer using 192.168.0.* in
your PC network. However for the first time using the decoder, you will have to set PC to
192.168.1.* in order to log into the decoder to change its default IP address from
192.168.1.169 to 192.168.0.169 (for example
Table of contents
