Ibx Roc-B1 User manual

Roc-B1 Rocking shaker with digital screen
and timing function
Please read the User Manual carefully before use, and follow all operating and safety instructions!
user manual
english

2
User Manual
Roc-B1 Rocking shaker with digital screen and timing function
Preface
Users should read this Manual carefully, follow the instructions and procedures, and beware of all the cautions
when using this instrument.
Service
In order to guarantee this equipment works safely and efficiently, it must receive regular maintenance. In case of
any faults, do not try to repair it yourself. If help is needed, you can always contact your supplier or Labbox via
www.labbox.com.
Please provide the customer care representative with the following information:
•Serial number
•Description of problem
•Your contact information
Warranty
This instrument is warranted to be free from defects in materials and workmanship under normal use and service,
for a period of 24 months from the date of invoice. The warranty is extended only to the original purchaser. It
shall not apply to any product or parts which have been damaged on account of improper installation, improper
connections, misuse, accident, or abnormal conditions of operation.
For claim under the warranty please contact your supplier.

3
1. Installation Instructions
1. Carefully unpack the instrument and place it on a stable, clean, non-slip, and fireproof surface.
2. Ensure a good working environment free of any combustible media or flammable materials to avoid
additional hazards.
3. Place the shaker at more than 10 cm from the wall and other units if using multiple units together.
4. Ensure that there is no accidental spillage during speed setting.
5. Do not use any combustible media or flammable materials to avoid any additional hazards.
6. Ensure that the label indicates the correct voltage before connecting the unit to the power supply.
7. Do not operate the unit with a damaged power cord.
8. Disable the power supply while fitting the accessories.
9. Ensure that the unit and its accessories are in good working condition before each operation.
2. Operating Procedure
1. Switch ON the power and the instrument will start self-checking.
2. Press the “Mode” key and the unit will enter the adjustment mode.
3. Press the “+/-” keys and confirm the set speed and time. Adjust the speed and time to the desired
settings. When the set time is 0, the screen displays “Hold”and switches to continuous mode.
4. Press the “Start” key and the instrument will begin shaking.
5. Press the “Stop” key to stop the operation and return the unit to adjustment mode.
3. Troubleshooting and Error Code Information
Error
Code
Problem
Reason
Solution
E01
No operating
response found (LED
OFF)
Power switch is OFF
Check and connect the power
supply before restarting. Check the
adapter.
Switch position is OFF
Turn on the instrument and check
the speed set on the LED display.
Internal cables
disconnected
Open the instrument and check all
connections before reconnecting
them.
E02
The shaking board
operation failure
Target speed is not set
Set the target speed and make
sure the indicator lamp is ON.
Driver board damage
Replace the driver board.
Motor damage
Replace the motor.
E03
Inaccurate shaking
speed
Driver board damage
Replace the driver board.
Photoelectric switch
damage
Replace the photoelectric switch.
E04
Shaking speed is
jammed
Driver board damage
Replace the driver board.
Motor damage
Replace the motor.

4
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. However, please be aware that this
equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance
with the instruction manual, it may cause harmful interference to radio communications. If this equipment is
operated in a residential area and causes harmful interference, the user will be required to correct the
interference at their own expense.

5
.

www.labbox.com