ICARVISIONS JA-MC818 Instruction sheet

摄像头安装指导
Vehicle-Camera JA-MC818
Install specification

摄像头安装指导
Please contact the manufacturer at any time due to the difference between the
various models or the upgrade of the system software. The contents of this
installation guide will be updated from time to time without notice.
一、Camera installation steps
Installation tools and auxiliary materials:
Adhesive 3M Sticker
1、Clean the camera mounting base
Use a cleaning cloth, a towel to clean the camera's surface.

摄像头安装指导
2、Use adhesive
Make sure the camera paste surface is dry, and bring a one-time dining plastic gloves, the
adhesive will be prepared evenly coated on the camera paste surface. Wait for about 10 seconds
and pay attention to the glue without too much to avoid overflow waste.

摄像头安装指导
3、Use 3M sticker
Make 3M stickers and camera pasted and fixed tight, and press for 30 seconds.
4、Install the camera to the front glass

摄像头安装指导
First use the wipes to make the glass clean and dry, and then paint with a layer of adhesive,
after about 10 seconds stick 3M stickers, press 30 seconds.
Finally, make camera forced on the glass (slowly press on the glass on one side to avoid the
formation of blisters), press 20-30 seconds without moving, after 20-30 seconds, the camera will
firmly erect on the glass.
Note: Do not tear off due to the light sticky and not tight, then when try again please ensure to
paste it once in place. If you tear off the and paste one more time, you need to use the new 3M
stickers, re-follow the installation steps
Installation angle shown as follow:

摄像头安装指导