ICP WS-855A User manual

WS-855A
User Manual
Version 2.2
<Product Overview>
15” TFT Display
10-slot Workstation
January 20, 2004

1
Copyright Notice
© Copyright 2004 by ICP Electronics Inc. All rights reserved.
No part of this manual may be reproduced, copied, or translated without prior
notice to ICP Electronics Inc.
The information provided in this document is for reference only. We do not
assume any responsibility arising out of the application of the products. This
manual is subject to change without any notice.
WS-855A and ICP is trademark of ICP Electronics Inc.

2
Table of Contents
Chapter 1. Product Information ........................................ 3
1.1. General Information................................................ 3
1.2. Product Specifications ............................................. 4
1.3. Dimensions............................................................ 6
1.4. Front Accessible CD-ROM, 3.5" FDD .......................... 7
1.5. The Membrane Keypad ............................................ 8
Chapter 2. System Setup .................................................. 9
2.1 Adding Cards ......................................................... 9
2.2 Disk Drives installation ............................................ 9
2.3 Power Supply Installation....................................... 11
2.4 Cooling Fan Installation ......................................... 12
2.5 Panel Mounting..................................................... 13
2.6 Rack Mounting ..................................................... 14
Chapter 3. Maintenance .................................................. 15
3.1 Power Supply ....................................................... 15
3.2 Cooling Fan.......................................................... 15
3.3 Disk Drives .......................................................... 15
Appendix B Keypad........................................................... 17
A. Block Diagram............................................................. 17
B. Jumper Setting............................................................ 17
Appendix C User Mode OSD Item Description................... 19
Appendix D Touch Panel Controller................................... 22
Appendix E Touch Pad ...................................................... 23
Appendix F CHECK LIST ................................................... 24

3
Chapter 1. Product Information
1.1. General Information
The WS-855A series workstations take advantage of modern flat-panel display,
CPU board, power supply and passive backplane for minimum size. It is an IBM
PC/AT compatible computer specially designed to meet the applications for
industrial working environments.
 LCD Display
WS-855A is equipped with a color 1024x768 resolution 15" TFT LCD.
 Versatile Passive Backplane
WS-855A can be equipped with PCI-10S (standard), PCI-10S2, BP-10S,
IP-10S or PX-10S 10-slot backplane.
 Sealed-membrane Accessible Keypad
The sealed-membrane keypad has 59 data keys including 10 function keys to
allow users enter data directly. Users also can attach the external keyboard
through a connector on the front panel of WS-855A.
 Power Switch, Ext. Keyboard and USB Port
The front lockable drive door protects the Power switch, Ext. board and the
USB port.
 Optional Touch Screen
Touch Screen: Analog resistive type with RS-232 interface controller.
 Power Supply
WS-855A is equipped with ACE-832A, 300W ATX industrial power supply.
 Optional Power Supplies
ACE-925T/932T/828T –48VDC input
ACE-925C/828C +24VDC input
ACE-916V +12VDC input
 Dimensions
483(W)x354(H)x265(D)mm.

4
Product Specifications
 Front Panel: Aluminum meets NEMA 4 or IP65.
 8U Height, rack-mount or panel-mount with front LCD on/off switch.
 Disk Drive Bay: Support one 5.25" Drive CD-ROM, one 3.5" FDD and one 3.5" HDD.
 59 entry keys including 10 function keys.
 Lockable drive door design & anti-vibration card clamp included.
 Backplane: PCI-10S (standard), PCI-10S2, BP-10S, IP-10S, PX-10S 10-slot backplane.
 12cm ball bearing cooling fan with removable fan filter.
 Display Module
SPEC IFICATIONS WS-855A
LCD Type AU-15.0” XGA Color TFT-LCD
Single Supply Voltage +12 VDC
Panel Size 15” Diagonal
Viewing Area 304.1mm x 228.1mm
Number of Pixels 1024 (W) x 768 (H)
Pixel Format 1 pixel = R + G + B dots
Pixel Arrangement R, G, B Vertical Strip
Pixel Pitch 0.297mm (H) x 0.297mm (V)
LCD Display Colors 262K, 18bits
Brightness 250 cd/m2
Viewing Direction 6 o’clock (in direction of max. contrast)
Viewing Angle 60˚(LEFT), 60˚(RIGHT), 40˚(UP), 40˚(DOWN)
Contrast Ratio > 400:1
Surface Treatment Anti-glare and Hard Coat 3H
Backlight Twin cold-cathode fluorescent lamps for side
lighting
Operating Temperature 0~50 ℃
Storage Temperature
LCD MTBF 50,000 hours
Backlight MTBF 25,000 hours (min)
Input VGA Input
OSD OSD built
 Dynapro Touch Screen (Optional)
Type: Analog Resistive
Resolution: Continuous
Light transmission: Typical value 72%
Surface Hardness: 4H (Test condition: ASTM D3363-92A)
8-wire touch screen
Support driver: Supports DOS, Windows 3.1, 95, 98, 2000, NT.

5
 Industrial Power Supply
Power Supply: ACE-832A, 300W industrial power supply
Shock: 10 G peak acceleration (11 msec. duration)
Safety: meet UL/CSA/TUV
EMI: meet FCC/VDE class A
 Environmental Specifications
Operating Temperature : 0 ~ 50℃
Relative Humidity: 10-95% @40 ℃, non-condensing
Vibration: 5 to 17 Hz, 0.1"double-amplitude displacement,
17 to 500 Hz, 1.5 G Peak to peak

6
1.2. Dimensions
The following diagram indicates the dimensions of WS-855A.
'
`
279.4
483
76.2255
211
413.4
265
10
334
443
354

7
1.3. Front Accessible CD-ROM, 3.5" FDD
WS-855A workstation is equipped with one 5.25˝CD-ROM and 3.5˝FDD that can
be accessible by opening the front lockable drive door as shown in the following
diagram. Power ON/OFF switch, Ext.-keyboard and USB port are also accessible
through this same front lockable drive door.
** For detail OSD item description, please refer to Appendix C User
Mode Operation.
`
'

8
1.4. The Membrane Keypad
The sealed-membrane keypad has 59 keys including 10 function keys to allow
users enter data directly. Users can also attach the external keyboard through a
connector on the front panel of WS-855A. A built-in controller will merge the
signals from the membrane keypad and general keyboard into one signal, which
acts as a standard IBM PC/AT keyboard.
'
`

9
Chapter 2. System Setup
The WS-855A 15" TFT LCD 10-slot workstation is very easy to set up for
operation. All you have to do is to open the back cover, install your CPU card,
display control card, hard disk drive and other I/O cards required by your
application, and you are ready to mount into a 19" rack or within a panel and
start to operate.
2.1 Adding Cards
Before installing the cards, the rear cover should be removed first by releasing
the screws as illustrated in the diagram below. Then, users can slowly slide the
card in and carefully press it into the slot of backplane. Please use the clamps
shown in the diagram to affix your cards.
2.2 Disk Drives installation
WS-855A is equipped one 5.25" Drive CD-ROM, one 3.5" FDD and one 3.5" HDD
which should be installed from the rear of chassis. Users must use the clamps to
fix 5.25˝CD-ROM, 3.5˝FDD and 3.5˝HDD. Please refer to the diagrams below.
Card Clamp
Holding CLAMP
FOR:ISA-CARD
FOR :PCI-CARD