iGenix IG8650 User manual

200W HAND BLENDER
Model Number: IG8650
INSTRUCTIONS FOR USE
Thank you for purchasing this product.
Please read these instructions carefully before use

2
Trouble with your hand blender? …
Try our troubleshooting guide on page 4.
If that does not solve the issue contact us …
SAFETY INSTRUCTIONS
Important: This appliance is not intended for use by persons including children with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
•Please read all instructions carefully before using the hand blender for the first time.
•Before plugging in the hand blender, check if the voltage indicated on the rating label corresponds with the main
voltage in your home.
•This hand blender is for household indoor use only. Never use it outdoors.
•Children should not be allowed to play with hand blender
•Never leave the hand blender unattended whilst plugged into the mains wall socket.
•Close supervision is necessary when the appliance is used around children or persons with reduced physical,
sensory or mental capabilities.
•Do not use for anything other than its intended use.
•Do not immerse the motor unit of the hand blender or cord in water or any other liquid.
•Do not use it in a bathroom, near water, or outdoors.
•Keep hands away from the spinning blade.
•Ensure hands and utensils are out of the container when blending to avoid risk of severe injury.
•To avoid risk of severe injury never place the cutting blade on the base without first putting bowl in place
properly.
•Do not blend hot food or liquids.
•Do not blend foods containing hard objects that cannot be safely broken up by the blade.
•Do not place hand blender on or near a hot hob / heated oven.
•Maximum operation time under high speed should not exceed 1 minute per cycle. The hand blender will require
10 minute for the motor to cool down between cycles.
•Do not allow the power cord to have over the edge of the counter where it can be pulled by children.
•Do not pull on the cord to disconnect the plug from the mains wall socket.
•Do not use if the power cord or plug is damaged. Do not replace the power cord or any other parts yourself.
•The hand blender should not be used if it has been dropped or if there are visible signs of damage.
•Always unplug the hand blender before assembling, disassembling or cleaning.
SPECIFICATION
Supply Voltage:
220-240V ~ 50Hz
Maximum Output:
200W
Postal Address:
Customer Service Department
Pik-a-Pak Electrical Distributors
38 Bluestem Road,
Ransomes Europark,
Ipswic , IP3 9RR
Tel: [phone] Fax: [phone]
Email: [email protected]k Website: www.igenix.co.uk
When writing or emailing us to report a fault please ensure you attach a copy of your proof of purchase.
Please retain your original

3
Before First Use
Clean the hand blender by holding inside a cup or bowl of warm water and turning the power on for a few seconds.
Please Note: When cleaning do not run the hand blender for longer than 15 seconds.
Using Your Hand Blender
Important: The blades are extremely sharp, handle with care. Ensure that the hand blender is unplugged before
assembling, disassembling or cleaning the blades.
1. To assemble the detachable shaft with the motor unit, turn the shaft in an anti-clockwise direction until
tightened. To disassemble turn clockwise.
2. Plug the hand blender into the mains power outlet.
3. Lower the hand blender into a suitable mixing bowl and depress and hold either the low or high speed switch at
the top of the motor unit.
4. To stop the hand blender take your finger off the switch.
Cleaning and Maintenance
•Unplug the hand blender from the mains power outlet.
•Remove the detachable shaft from the motor unit. Do not immerse the motor housing in water or any other
liquid.
•Wash the detachable shaft under running water. Place the stem on the draining board upright so that the
excess water can drain away. The detachable shaft is dishwasher safe.
•Wipe the motor unit with a soft damp cloth. Do not immerse in water.
•Ensure all parts are dry before re-assembling.
Quick Wash: Clean the hand blender by holding inside a cup or bowl of warm water and turning the power on for
a few seconds. Please Note: When cleaning, do not run the hand blender for longer than 15 seconds.
IG8650 – Hand Blender at a Glance

4
Troubleshooting
If you are having problems with your product, please use our troubleshooting guide below. If you are
unable to resolve the issue using the guide please ring our Customer Service Department on
01473 271 272. Please have the model code, batch number and purchase information available.
Problem
Possible Cause
Solution
The hand blender does not work.
1. Motor unit and shaft not
connected correctly.
2. Not properly plugged into the
mains wall socket.
3. No electricity in the mains wall
socket.
4. The motor may have overheated
1. Check that the shaft and motor
units are connect correctly.
2. Plug in firmly.
3. Check fuse or breaker.
4. The blender should only be run
continuously for a maximum time
of 1 minute to prevent the motor
from over heating. After1 minutes
use allow the hand blender to
cool down for 10 minutes.
This hand blender must be earthed. Fit a 3A fuse in a 13A BS1363 plug. Fit the
green/yellow wire to E, the blue wire to N and the brown wire to L. Fit the cord grip. If
in doubt, call an electrician. Don’t use a non-rewireable plug unless the fuse cover is
fitted. If you remove the plug, dispose of it.
Guarantee Information
This product is guaranteed for a period of 2 years from the date of purchase against
mechanical and electrical defects.
The warranty does not
cover consumable parts that require replacement under normal
use or accessories. This includes beaker, belts, and accessory attachments.
1. If a fault develops within 28 days of purchase the item should be returned to the
place of purchase for exchange.
2. If the fault develops after 28 days and within 24 months of purchase please contact
our customer service department 01473 271 272 or write to us at the address
detailed on page 5.
Please quote the model number which begins IG, the ‘Batch Number’ beginning ‘5’ and
give details of the exact fault.
We will then decide whether to repair or replace the item. You will be required to return a copy of your proof of
purchase. Please retain your original.
If an item is replaced under guarantee within 2 years, the guarantee for the replacement item will be calculated
from the purchase date of the original.
Before calling the Customer Service number please ensure you have checked the
Troubleshooting guide.
Postal Address:
Customer Service Department
Pik-a-Pak Electrical Distributors
38 Bluestem Road,
Ransomes Europark,
Ipswic , IP3 9RR
Tel: [phone] Fax: [phone]
Email: [email protected]k Website: www.igenix.co.uk
When writing or emailing us to report a fault please ensure you attach a copy of your proof of purchase.
Please retain your original

5
Disposal of Old Electrical Appliances
The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in normal unsorted municipal waste.
Old appliances must be collected separately in order to optimize the recovery and recycling of the
materials they contain and reduce the impact on human health and the environment. The crossed out
“wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the
appliance it must be separately collected. Consumers should contact their local authority or retailer for
information concerning the correct disposal of their old appliance.
Disclaimer
Updates to hardware components are made regularly. Therefore some of the instructions, specifications and
pictures in this documentation may differ slightly from your particular situation. All items described in this guide are
for illustration purposes only and may not apply to your particular situation. No legal right or entitlements may be
obtained from the description made in this manual.
View the range online at www.igenix.co.uk