IKI Water heater 50 litres User manual

IKI Water heater 50 litres
© IKI-Kiuas Oy
1. Lift the water heater on to the top of the stove.
The hinged lid with a handle should be facing upwards
and the pipe that goes through the tank must be tted
tightly over the stove’s ue pipe.
2. Ax the water heater on to the stove’s mesh
frame using the metal support bracket that is
included in the delivery.
NOTE:
Stones must be carefully loaded on to the stove. When using a ue pipe water heater, it is particularly important to
place stones inside and in between the coiled stove pipe to support the added weight of the water tank. Over time,
the weight of the tank may push the coiled pipe down a bit.
During heating and operation, make sure the heater is lled with water (at least two thirds full).
If and when the temperature in the sauna drops below zero degrees, any water left in the heater will freeze and
expand, which can damage the tank and the tap. To prevent this, always empty the tank through the tap after
bathing and leave the tap open.
If the lid’s handle is on the wrong side,
simply unfasten the handle’s screws
and ax it on to the other side.

IKI Water heater 50 litres
Connection heights with 90-degree pipe
© IKI-Kiuas Oy
1565 mm 1495 mm
1865 mm
1665 mm
Mini-IKI Original IKI
Maxi-IKI Löyly-IKI
1235 mm
1335 mm
1535 mm
1165 mm