IL Motorsport NC0-0965 User manual

Installation Instruction
Brace Kit
NC0-0965
© Copyright I.L.Motorsport GmbH Innungstr. 1 50354 Hürth-Gleuel Tel.: [phone] Seite 1 von 2
Figure 1
To fit the front strut, loosen the screws on the point 1 to 5 and remove the original brace
(Figure 1).
When mounting the aluminium strut using the original bolts.
Figure 2 Figure 3
Now loosen the screws at position 6-16 and remove the original struts. Once assembled,
attach the rear strut first with the original struts at points 16 and 13 with the supplied bolts.
The rear torque arm is installed under the original strut (Figure 5)
Now take the middle piece (Figure 3) and secure with the new hexagonal bolt M12x1,25 at
position 12 and 15. At points 11 and 14 use the original screws.
A
llen ke
y
bolts

Installation Instruction
Brace Kit
NC0-0965
© Copyright I.L.Motorsport GmbH Innungstr. 1 50354 Hürth-Gleuel Tel.: [phone] Seite 2 von 2
Attach the cross brace with the supplied M8 screws at positions 7 to 10, and the original
screw to the point 6.
Figure 4
Check the tightness of all the bolts using the torque setting chart below.
Figure 5
Torque settings
1 17,7 – 26,5 Nm 09 17,7 – 26,5 Nm
2 17,7 – 26,5 Nm 10 17,7 – 26,5 Nm
3 17,7 – 26,5 Nm 11 62,7 - 93,1 Nm
4 17,7 – 26,5 Nm 12 62,7 - 93,1 Nm
5 3 – 5 Nm 13 62,7 - 93,1 Nm
6 7,8 – 11 Nm 14 62,7 - 93,1 Nm
7 17,7 – 26,5 Nm 15 62,7 - 93,1 Nm
8 17,7 – 26,5 Nm 16 62,7 - 93,1 Nm
17,7
-
26,5
Nm
17,7
-
26,5
Nm
17,7
-
26,5
Nm
17,7
-
26,5
Nm
17,7
-
26,5
Nm
17,7
-
26,5
Nm