iLive DS-1181 User manual

DS-1181 manual
Introduction:
A1 A2 A3
A1: Vol-
A2: Play/Pause
A3: Vol+
B2
B2: Pair button

C1 C2 C3 C4
C1: Light button
C2: USB port
C3: Line In jack
C4: Power switch
Pairing a Bluetooth Device
1. Turn on the unit using the Power switch. The Pairing indicator will flash blue slowly.
2. Hold and press Pair button for 3s to go to pairing mode, the Pairing indicator will flash blue
quickly.
3. Using the native controls on your Bluetooth device, select the “DS-1181” in your Bluetooth
settings to pair.
3. When successfully paired and connected, the Pairing Indicator will display solid blue and a beep
will sound from the unit.
4. To terminate bluetooth connection, hold Pair button for 3s.
After initial pairing, the unit will stay paired unless unpaired manually by the user to hold and press
Pair button for 3s.
Playing Audio Wirelessly
1. Follow the instructions for Pairing a Bluetooth Device.
2. Use the native controls on the connected Bluetooth device to select a track.
3. To play, pause the selected track, use the native controls on the connected Bluetooth device or
press the Play/Pause button on the unit.
4. Audio played through the connected Bluetooth device will now be heard through the speakers.
5. Press and hold the Vol+/Vol- buttons to adjust the volume.

Using the 3.5mm Audio Input
1. Plug one end of a 3.5 mm audio input cable (included) into the 3.5 mmAudio Input on the unit.
The Pairing/Line In Indicator will display a red light.
1. Plug the other end of the cable into the audio output/headphone output on an MP3 Player or other
audio source.
2. Turn on the unit using the Power switch.
3. Audio played through the connected device will now be heard through the speakers.
Note: Any audio being played through a connected Bluetooth Device will cease once the 3.5mm Audio
source is connected.
Charging Indicator
Red: Charging
Off: fully charged
Flash red: lower battery
Charging for external devices
Speaker comes with USB port for charging external device such as smart phones, use a USB
cable(not included) for charging.
Lamp
Speaker comes with White Lamp for lighting, switch LIGHT button to turn on/off lamp.

FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.