iLive ISBW246B User manual

MICRO SDAUX
PAIR
DC IN
OFF/ON
MIC
Overview
Wireless Water Resistant Speaker
User’s Guide for Model ISBW246B v1549-01
Pair Bluetooth
Press and hold to begin pairing
to a Bluetooth device.
Skip/Volume +/-
Press to skip audio tracks.
Press and hold to adjust volume.
Play/Pause/Speakerphone
Press to play or pause an audio track.
Press to answer an incoming call.
Press and hold to switch between
Bluetooth, SD and FM Radio modes.
Power Switch
Aux In
Micro-USB Charging Port
LED Light ON/OFF
Press 1 - ON
Press 2 - Dim
Press 3 - Flashing
Press 4 - OFF
LED Light
Rubber Control Cover
Micro SD
Card Port
Pairing Indicator
Speaker
Microphone
Includes
• Micro-USB to USB charging cable
• Handlebar bracket
• Wrist strap
• User’s Guide
Attach to Bicycle Handlebar
Features
• IPX4 water resistant
• Built-in speaker
• Supports Bluetooth
• Wireless range: 60 feet
• Built-in microphone for speakerphone
• LED ashlight
• Micro-SD memory card reader
• Aux in (3.5mm audio input)
• DC battery power: built-in 2200mAH
rechargeable lithium ion battery
• Battery life: approx. 7 hours at 50% volume
FCC WARNINGS
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ADDITIONAL WARNINGS AND PRECAUTIONS
• To avoid hearing damage, make sure that the volume on your music player is turned down before
connecting your headphones. After placing headphones in/on your ears, gradually turn up the volume
until you reach a comfortable listening level.
• Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled or disposed
of according to state and local guidelines. They should never be disposed of in normal household
waste, and they should never be incinerated, as they might explode. Contact your local government for
disposal or recycling practices in your area.
• WARNING: This product may contain chemicals known to the State of California to cause birth defects,
or other reproductive harm (California Prop 65). Wash hands after handling.
• This product meets and complies with all Federal regulations.
Attach Handstrap

To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit
the support section at: www.iLiveElectronics.com
Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas
frecuentes, visite la sección de apoyo en: www.iLiveElectronics.com
Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des
questions fréquemment posées, consultez la rubrique d’assistance sur: www.iLiveElectronics.com
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.iLiveElectronics.com
Customer Service: 1-888-999-4215 | Email Support: [e-mail] | Email Parts: par[email protected]
Copyright © 2016 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property
of their respective owners. Specications are subject to change without notice.
International Support
Protect for Today
Sustain for Tomorrow
Made
Green
Bluetooth Wireless Audio
Pairing to a Device & Playing Audio
After initial pairing, the unit will stay paired unless unpaired manually by
the user or erased due to a reset of the device. If your device should become
unpaired or you nd it is unable to connect, repeat the steps listed here.
1. Power on the unit by sliding the POWER Switch to the ON position, then
press and hold the Pair button to begin pairing. The pairing indicator will
begin quickly ashing blue. When pairing, remain within 3 feet of the unit.
2. Using the controls on your Bluetooth device, scan for and select ISBW246 in
your Bluetooth settings to pair. If your device requests a password, enter the
default password 0 0 0 0 . Refer to the user’s manual for your specic device
for instructions on pairing and connecting Bluetooth devices.
3. When successfully paired, the pairing indicator will turn solid blue and an
audible chime will sound from the speaker.
4. Use the controls on the connected device to select and begin playing audio.
Audio played through the connected Bluetooth device will now be heard
through the speaker.
5. Use the controls on the unit or the connected device to play, pause, and
adjust volume.
Water Resistance
This unit has a water resistance rating of IPX4. This rating is suitable for indoor and
outdoor use in the presence of incidental or light exposure to splashing water,
rain, or snow. Water splashing against the enclosure from any angle should have
no harmful eects. It is not recommend to submerge this speaker in water for any
amount of time.
IMPORTANT: To ensure your speaker is prepared for use in a wet environment,
disconnect and remove any power cables, and tightly close the cover on the top of
the unit. If the cover is not properly closed, water resistance will be compromised
and could result in damage to the speaker or personal injury.
Charging the Battery
Requires a Micro-USB to USB cable (included).
1. Using a Micro-USB to USB cable (included), connect to the USB port of a
powered on computer or USB power adaptor to charge the unit. Charge
fully before use.
Aux In
Requires a 3.5mm audio cable (not included).
1. Connect a 3.5mm audio cable to the Aux In on the unit and the audio
output/headphone jack on a media player or smartphone.
2. Power on the unit by sliding the POWER Switch to the ON position.
The Aux input will be detected and the unit will automatically switch
to Aux In mode.
3. Use the controls on the connected device to select and play audio.
Micro-SD Card
1. Insert a Micro-SD card in the card slot. The speaker will begin playing
automatically.
2. Use the controls on the unit to play, pause, and adjust volume.
3. Press and hold the Play/Pause button to switch to a dierent mode.
FM Radio
1. Press and hold the Play/Pause button to switch to FM mode.
2. Press the Play/Pause button again to automatically scan for FM stations.
When the scan is complete available stations will be saved as presets.
3. Press the Skip buttons to cycle through saved stations. Press and hold
the Skip buttons to adjust the volume.
MICRO SDAUX
PAIR
DC IN
OFF/ON
MIC
MICRO SDAUX
PAIR
DC IN
OFF/ON
MIC
INDICATOR LIGHT STATUS
Red light ON Charging battery
Red light OFF Charging complete
Red light ashing Low Battery, charge soon