IMOU 1.0.1 User manual

About the Guide
- This quick start guide is for reference only. Minor difference might
be found in user interface.
- All the design and software here are subject to change without
prior written notice.
- All trademarks and registered trademarks mentioned are the
properties of their respective owners.
- Please visit our website or contact your local service engineer for
more information.
- If there is any uncertainty or controversy, please refer to our final
explanation.
with Imou AppOperating
Step 1
Step 3
Connect the camera to power source with the power adapter.
Scan the following QR code or search “Imou” in Google Play or App
Store to download and install Imou App.
Run Imou App, and then register an account for the first use.
Step 2
Note: If you have installed the App, update it to the latest version. Step 5
Step 4
Connect your smart phone to your Wi-Fi network, and make sure that your
smart phone is connected to Wi-Fi network with 2.4 GHz band, and then
do the following operations to finish adding camera.
Wait for booting to be finished, and then the camera indicator flashes
with green light.
Note:
If the Wi-Fi network has changed or the indicator status goes
wrong, reset the camera, and then do step 5 to add it again.
If you have more than one camera, do step 5 to add them
one by one.
Installing Camera
Step1Stick the mounting foam on the camera pedestal.
Step2Power up the camera.
Step3Adjust the monitoring angle as needed, and then attach the pedestal
on the mounting surface, press and hold it for 10 s.
Note:
Mounting Surface
Mounting Foam
Camera
Make sure that the mounting surface is smooth and strong enough
to hold at least three times of the device weight.
Select Wi-Fi
Wi-Fi XXXXXX1
Wi-Fi XXXXXX2
Wi-Fi XXXXXX3
...
Wi-Fi Password

Note: Press and hold the
reset button for 10 s to reset the camera.
IntroductionCameraListPacking
The pattern of the LED indicator is included in the following table.
LED Indicator Status Device Status
Green light flashing
Green light on
Red light flashing
Green and red lights
flashing alternately
Powered off/LED turned off
Rebooting after reset
Booting
Device malfunction
Waiting for network
Operating properly
Network connection failed
Off
Red light on
Firmware updating
Version 1.0.1
Quick Start Guide
Camera ×1 Power Adapter ×1
QSG ×1
1.2.51.32.16303-000
Power Cable ×1
Mounting Foam ×1
LED Indicator
Lens
Built-in Mic
Micro SD Card Slot
Power Port Reset Button