impact LSA-LW22P User manual

LSA-LW22P / LSA-LW25P
22 and 25 mm
Locking Wheel
INSTRUCTIONS

2
Introduction
Thank you for choosing Impact.
Specications
The Impact Locking Wheel Set ts on most tripod or light stand
legs with 22 mm (LSA-LW22P) or 25 mm (LSA-LW25P) diameter
tubes. The wheels feature sturdy construction, easy-to-operate
wheel locks, and metal brake shoes that assure a tight and secure
connection. The three-inch rubber wheels are easy to roll, even
on thick carpeting, and won’t scratch wood or polished surfaces.
Precautions ⚠⚡
• Please read and follow these
instructions, and keep this manual
in a safe place.
• Make sure everything is secure
before proceeding.
• Make sure that this product
is intact and that there are no
missing parts.
• All images are for illustrative
purposes only.
Connector Size LSA-LW22P: 0.9 in. (22 mm)
LSA-LW25P: 1 in. (25 mm)
Wheel Diameter 3 in. (75 mm)
Locking Wheels Yes
Material Steel, polymer
Weight (set of 3) LSA-LW22P: 2.9 lb. (1296 g)
LSA-LW25P: 2.8 lb. (1287 g)
Scan for a complete listing of our
studio equipment or visit
www.ImpactStudioLighting.com/se

3
Setup
Attachment Instructions
1. Install the brake shoe by sliding
it into the receiver’s notch. Make
sure the post is at the bottom of
the receiver.
2. Fully insert the tripod leg into the
receiver until it touches the post
3. Tighten the knob until secure.
Locking and Unlocking the Wheels
To lock the wheels, press or step
down on the locking lever.
To unlock the wheels, use your toe to
push back the release tab on top of
the wheel.

One-Year Limited Warranty
This Impact product is warranted to the original purchaser to be free from defects in materials
and workmanship under normal consumer use for a period of one (1) year from the original
purchase date or thirty (30) days after replacement, whichever occurs later. The warranty
provider’s responsibility with respect to this limited warranty shall be limited solely to repair
or replacement, at the provider’s discretion, of any product that fails during normal use of this
product in its intended manner and in its intended environment. Inoperability of the product
or part(s) shall be determined by the warranty provider. If the product has been discontinued,
the warranty provider reserves the right to replace it with a model of equivalent quality and
function.
This warranty does not cover damage or defect caused by misuse, neglect, accident,
alteration, abuse, improper installation or maintenance. EXCEPT AS PROVIDED HEREIN,
THE WARRANTY PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR ANY
IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty provides you
with specic legal rights, and you may also have additional rights that vary from state to state.
To obtain warranty coverage, contact the Impact Customer Service Department to obtain
a return merchandise authorization (“RMA”) number, and return the defective product to
Impact along with the RMA number and proof of purchase. Shipment of the defective product
is at the purchaser’s own risk and expense.
For more information or to arrange service, visit www.impactstudiolighting.com or call
Customer Service at 212-594-2353.
Product warranty provided by the Gradus Group.
www.gradusgroup.com
Impact is a registered trademark of the Gradus Group.
© 2021 Gradus Group LLC. All Rights Reserved.
GG3