Imperial Adjustable Rigid Riser User manual

INSTRUCT160
REV170131CM
General installation instructions for Adjustable Rigid Riser
Important Information:
Please check the products for transport damage and that contents are complete before
installation.
Consult a qualied plumber if you have any problems installing this product.
Complaints made following installation regarding the above cannot be accepted.

2 of 6
Please take a moment to review this manual before you install your product. If
you encounter any installation or performance problems, please do not
hesitate to contact us using the phone number listed on the back cover of the
booklet.
Upon receiving your product please open all cartons carefully and inspect for
any manufacturing defects or transit damage.
Imperial cannot be held responsible for damaged products after or during
their installation.
This installation guide and the fixings provided are intended for fixing into
solid walls. If you are installing this product into a stud wall structure or any
other type of non solid wall please amend your installation techniques and
fixings accordingly.
General Instructions
Tools Required
drill screwdriver spirit level pencil
Introduction and General Instructions
Thank you for purchasing this Imperial product.
These bathroom accesssories and complements are manufactured under rigorous quality control.
This is a product made with the finest materials. Its metal surfaces have received a protective
treatment that ensures its resistance to ambient conditions.

3 of 6
Ensure that you have a clear space in which to work.
After having instaled a wall outlet 1/2”M, proceed with the assembling
of the shower pipe.
rail bracket A
G.1/2”
Ø
200
water inlet
955-1285
Ø 20
Ø
25
65-85
660
765
G.1/2”
7
350
5
fixing holes
2
1
3
4
nut 1/2” female
1/2” male
1/2” male
nut 1/2” female
1/2” female
6
NOTE: Riser pipework MUST not be cut.

4 of 6
Installation Instuctions
1. Assemble the diverter (1) to the shower pipe (2) using the 1/2” supplied
washer.
2. Assemble the wall bracket (3) to the diverter body and connect the 1/2”
nut (4) to the wall.
3. Take the wall bracket (5) and position it to the upper side of the pipe, mark
the hole on the wall and fix it with the supplied screws.
4. Cover the wall bracket with the cover plate (6).
Adjust the height of the shower pipe using the nut (A).
NOTE: Riser pipework MUST not be cut.

5 of 6
Metal:
Parts with Chrome/Gold finish should be cleaned with a damp soft cloth only.
It is important to dry excess water after use to prevent staining and calcium lime
scale build up. Water that is allowed to dry on plated surfaces will stain and
damage the plated finish and over a period of time calcium will erode the
finish.
Imperial recommends the use of soap and water only for cleaning and ensure
that the product is thoroughly dried after with a soft lint free cloth.
Care should be taken with hand gels and mouth wash as they contain alcohol
which will burn and tarnish the plated finish.
The use of detergents and abrasive cleaning agents should be avoided as these
will cause damage to the finish of the metal.
By adopting Imperial’s recommended care and cleaning advice will give many
years of pleasure, we hope you enjoy your new bathroom fittings.
Care & Maintainance
You have just acquired a high quality bathroom accessory and are about to put it in
the most hostile environment in the house! We have been producing these fine
products for many years and our experience is that they will give years of pleasurable
service if a few simple measures are taken to look after them.

The Imperial Bathroom Company
England
www.imperial-bathrooms.co.uk
Tel: [phone], Fax: [phone]
Email: [email protected]