inbody 270 User manual

InBody
Keep the box right side up.
Slice between the flaps to open the
unit box. Do not cut too deeply or
you may damage the contents.
Unfold and take out all the padding
on top to reveal the unit.
Once you place the unit on the
ground, use one hand to hold the
footplate and the other hand to
push the head upright to a vercal
posion unl you hear a click.
Li the unit up from the box,
making sure you are holding onto
the footplate with both hands.
Keep the footplate horizontal to
the ground. (This may require two people)
Do not cut too deep when opening up the unit box. Cung too deep may damage the InBody unit and/or unit padding.
Your InBody 270 package comes with the following:

| Quick Installaon Guide www.inbody.com
1
4 5 6
2 3
UNBOXING + ASSEMBLY
Tilt the head upright and
straighten out the handles.
Check the level indicator to
see if the unit is balanced.
If not level, adjust the four
footplate supports unl the
bubble is inside the red ring.
Rotate clockwise to lower the
height of the support or
counterclockwise to raise it.
Connect the adapter to the
power input port located on
the rear panel of the unit.
Connect the adapter to the
power cord. Plug the power
cord into an outlet.
Leveled Not leveled
Level Indicator
Adapter User’s Manual
Power CordInBody 270


2 3
PASSCODE SETUP
Turn on the InBody unit by using
the switch on the back of the unit.
(Note: Make sure there is nothing on top of the footplate
when turning on the unit for proper calibraon.)
Once the home screen appears,
access the “Administrator Menu”
by using the default password
“0000”.
You’ll be prompted to enter a new

“0000” if you do not wish to enter a
new password.
(Note: Due to HIPAA regulaons, reseng a forgoen
passcode will require signed documentaon to be submied
to InBody by the owner or facility manager before reset
steps are provided)
2 3
UPDATE YOUR LOGO
Locate your InBody USB thumb drive
from the unit box. If requested,

to your USB thumb drive.
(If you did not request a modified logo and would like to
receive one, please contact our support department at
[email protected]om with an image file of your desired logo
and the InBody model type it will be used for.)
Remove the USB thumb drive from

using a computer to prevent any

Exit the Administrator Menu for

2
PRINTER SETUP
Insert the power cord into the
printer’s power slot and the other
end into an outlet. Insert the USB
cable into the printer’s USB slot
and the other end into the back of
the InBody unit.
For more detail about assembly or synching, refer to the user manual or visit the InBody Academy.
 Copyright 2021, InBody USA | All Rights Reserved

DATE/TIME SETUP

“Administrator Menu”.
Adjust to your current date and

(Time is displayed as a 24-hour format, but will show up
on your Result Sheet as a standard 12-hour format.)
Load the InBody Result Sheets into
the printer and press the power

InBody



14” inside the “Administrator Menu”.


logo image will be displayed in the
“Preview of Custom Logo” area.