
17
ENGLISH
OFFSET VALUE
This is the information needed to align the temperature shown on the display with the actual
temperature inside the refrigerated compartment. Each o-set can be adjusted within a range of
from -10 to +10.
After running the refrigeration system for a few hours, place a digital thermometer (not supplied)
inside the compartment and check that the temperature shown on the display coincides with the
temperature shown on the digital thermometer. If the temperature is not the same, the o-sets
must be adjusted in relation to the temperature Tyou want the inside of the compartment to
reach, so that the temperature reading on the display coincides with the temperature indicated by
the thermometer.
The following table shows the factory o-set setting for each temperature range and the
adjustment range for changing these settings.
OFFSET FUNCTION VALUE DEFAULTED WHEN SHIPMENT
LEFT BIN RIGHT BIN
F1
Set temperature≥0°C, temperature
compensation value 2°C -5°C
F2
-1°C≥Set temperature≥-
14°C,temperature compensation value 2°C -7°C
F3
Set temperature≤-15°C, temperature
compensation value 2°C -7°C
SETTING TEMPERATURE COMPENSATION
• When the fridge is switched o, keep pressed for 3 seconds the two left-bin buttons ”∧” and
“∨” at the same time to enter the temperature compensation mode.
• In the temperature compensation setting mode, the display will show F1/F2/F3. Press the “
” button to switch from an o-set value to the following one. The display will show before
the o-set values of the left-bin, then the o-set values of the right-bin.
• Press the lighted ”∧” and “∨” buttons to set the selected parameter.
• The default o-set values are shown above.
FILLING
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them
hitting against each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
DEFROSTING
Defrosting is needed when the layer of frost is thicker than 4 mm. To carry out this operation, turn
o the refrigerator. Do not use sharp or cutting tools to remove the layer of frost or ice. Wait until
complete unfreezing and then turn on again.