Indesit SCM1 User manual

SCM1
Scholtès automatic,
built-in coffee machine

SCM2
Scholtès automatic,
built-in coffee machine

Contents
1) Technical Specifications
2) Accessibility
3) Wiring diagram
4) Water circuit diagram
5) Test procedures
6) Troubleshooting
7) Technical info
Scholtès automatic,
built-in coffee machine

Technical Specifications

Accessibility
Removing the surround
vi
Unscrew the first
six screws
securing the
surround on the
right hand side -
Unscrew the first
six screws
securing the right
side of the
surround......
… and the other
six screws
securing the
surround on the
left.
continued

Accessibility
Unscrew the three screws securing
the surround at the top, near the brew
group.. … and the two screws at the
bottom. continued
Removing the surround

Accessibility
continued
Unscrew the two screws
securing the cover on the
right ,...
... and the 1 screw on the left
(be careful when putting back
together).
Removing the surround

Accessibility
Removing the surround
On taking off the
cover, remove the
faston and other
connectors, as shown
in the photo.

Accessibility
Removing the surround
Unscrew the screw
on the left and
.. on the right. If this is too
awkward to do, we recommend …
remove the switch and ..
… unscrewing the
3 screws.
The cappuccino
foamer pipe can then
be pulled out.

Accessibility
To remove the outer casing, unscrew the
3 screws in the rear panel.
continued
Removing the rear panel.

Accessibility
Removing the casing
… and unscrew
the screws
shown in the
photo on both
the right and
left.
Caution: there
is also a screw
at the bottom of
the trays.
Remove the casing.

Accessibility
Removing cover
To remove the
cover, unscrew
the 4 screws as
shown in the
photos.

Unscrew the
2 screws securing
the finger guard and
pull it upwards to
remove.
Unscrew the
plastic cap
Dismantling the coffee grinder
Accessibility

Dismantling the coffee grinder
Unscrew the
3 screws securing
the coffee bean
hopper.
Accessibility

Accessibility
Dismantling the coffee grinder
Unscrew the
screws
securing the
knob.

Accessibility
Dismantling the coffee grinder
Lift off the bean
hopper.

Accessibility
Dismantling the coffee grinder
Disconnect the two
faston connectors
from the motor and
pull the grinder up
and out.

Accessibility
Dismantling the flow meter
Detach
connector Using a screwdriver as a
wedge, unhook the
flowmeter
Flow meter
Unscrew the rubber
cap
Detach
connector

Accessibility
Dismantling the pump
Ulka pump
Pull out the small
spring
Pull out the tube; be
careful with the o-ring
Remove the wire
spring
Pull out the
tube
continued…

Accessibility
Dismantling the pump
Holding the pump lug with a
12mm spanner, unscrew the
valve + damper assembly
Pull out the
tube
feeding into
the pump
Pull the pump
out from its
rubber support,
first from the
bottom then from
the top.