16
GB
Care and Cleaning
Ceramic hob
To reduce the amount of cleaning always ensure that
the hob and cooking utensils are clean and dry
before use. Regular use of cleaner conditioner is
recommended for proper care and protection of the
hob surface. Apply conditioner before using the hob
for the first time. It contains a mild cleaning agent,
so that subsequent applications may clean off soil
and apply a protective film at the same time. For
stubborn stains or heavy soiling use any of the
following materials, and finish off with conditioner.
1.Cif, non-scratch scouring cream.
2.Liquid Gumption Kitchen Cleanser.
3.Special Powder Cleanser.
Powder CleanserPowder Cleanser
Powder CleanserPowder Cleanser
Powder Cleanser – Mineral deposits that are
present in hard water, and some foods, may cause
‘discolourations’ that appear in the form of grey or
brown stains. The stains sometimes appear to be in
or under the glass surface. If there are some
persistent stains after using any of the other
recommended cleaning materials, powder cleanser
may be applied, following the manufacturers
instructions. Do notDo not
Do notDo not
Do not use abrasive cleaners or the
powder cleanser on the painted metal framework.
Cleaner ConditionerCleaner Conditioner
Cleaner ConditionerCleaner Conditioner
Cleaner Conditioner – Regular use of the
conditioner will make the surface easier to cl
Grill
Removethe grillpan andthe wiregrid foodsupport, it
is best to wash these items immediately after use to
preventstains frombeing burntonwhen usedagain.
Wipe out the Grill compartment, use a fine steel wool
soappad toremove stubbornstains fromthe grill
runnersand thefloor ofthecompartment. Wipeover
the control panel with a damp cloth and polish with a
dry cloth.
Control Panel
Do not use creamcleaners, ovencleaners or
aerosols,scouring padsorabrasive powderfor
cleaning the plastic knobs as damage will occur.
Decorative Trims
Itis advisable toclean thedecorative trims regularlyto
preventany buildupof soiling.Therecommended
method of cleaning is to wipe over the trims with a soft
clothwrung outin warmwateror mildnon-abrasive
cleaner. (If in doubt try the cleaner on a small area of
trim which is not noticeable in normal use). Then, after
wiping with a cloth wrung out in clear water, dry with a
soft clean cloth.
Doors
Wipe over the outer door glass panels with a cloth
wrungout inwarm soapywater, thenafterwiping with
a cloth wrung out in clear water, dry with a soft clean
cloth. Ensure that glass doors are not subjected to
any sharp mechanical blows.
Glass Inner Door Panel (where fitted) – open the
door fully and unscrew the two screws securing the
glass panel, taking care not to allow the glass to fall.
The glass panel may now be washed at the sink.
Stubbornstains canbe removedby usinga fine steel
wool soap pad. Ensure the glass panel is not
subjected to any sharp mechanical blows. Take
particularcare notto damagethe innersurface which
iscoated witha heatreflective layer. Aftercleaning,
rinse and dry with a soft cloth. For slight soiling the
inner glass panel may be cleaned, while still warm,
withoutremoving itfromthe door.
Warning: Oven must not be operated with inner
door glass removed.
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the oven
chassis, if necessary remove the seal by carefully
unhookingthe cornerclips.
Take care that the rating label edges are not lifted
duringcleaning, andfurthermore thatthe letteringis
notblurredor removed.
Ovens
Removethe rodshelves andgrill pan.Use afine steel
woolsoap padto removestubborn stainsfrom therod
shelves,grill panand thefloor oftheoven.
Oven Shelf Supports
Theshelfsupports areremovableand dishwasher
safe.
To remove hold the support at the front and pull away
from the oven side, this can then be cleaned in a sink
or a dishwasher. When removed it allows access to
the oven side, which can be cleaned with warm soapy
water.
To refit the support, insert the longer leg into the rear
fixing hole and push in the front leg.
Oven Lamp Replacement
Openthe ovendoorandremove therodshelves.
Using a suitable cloth to protect the fingers grip the
light glass dome, unscrew anti-clockwise and lift.
Reachinto theaperture withfingers, andunscrew the
lamp anticlockwise. Fit replacement lamp (25W
300°Crated SES),refit dome.
WARNING: To avoid electric shocks - please ensure
that the electricity supply to the appliance is
switched off and the appliance is fully cold, before
removing the lamp lens.