Indesit DISR 57M96 User manual

www.sacoapartments.com welcome
Operating Instructions – Dishwasher Indesit DISR 57M96
Control Panel
Measuring out the detergent
Open the detergent dispenser using button D and measure out the detergent. Where the cycle requires 1 tablet,
place it in compartment A and close cover C. When it requires 2 tablets place the second tablet on the bottom of the
appliance.
Starting the dishwasher
1. Discard scraps off the crockery
2. Press the On/Off button
3. Measure out the detergent
4. Load the racks, ensuring the sprayer arms can move freely.
5. Select the wash cycle in accordance with the type of crockery and its soil level by pressing the P button.
6. Select the wash options

www.sacoapartments.com welcome
7. Start the wash cycle by shutting the door.
8. The end of the wash cycle is indicated by beeps and by the flashing of the wash cycle number on the display.
Open the door, switch off the appliance by pressing the On/Off buton.
9. Wait for a few minutes before removing the crockery, in order to avoid burns. Unload the racks beginning with
the lower level.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has
only just begun: open the door taking care to avoid the escaping steam, by pressing and holding the On/Off button,
the machine will switch off. Switch the machine back on using the On/Off button and select the new wash cycle and
any options desired; start the cycle by closing the door.
Adding extra crockery
Without switching off the machine, open the door, taking care to avoid the escaping steam, and place the crockery
inside the dishwasher. Shut the door and the cycle will begin from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the electricity supply is restored.

www.sacoapartments.com welcome
Wash cycles
Special wash cycle and options
To reduce consumption only run the dishwasher when it is full. If a wash option is not compatible with the selected
wash cycle (see table of wash cycles), the corresponding LED flashes rapidly 3 times and beeps will sound.
Delayed start option
The start of the wash cycle may be delayed for a period of time between 1 and 12 hours.
1. Press the DELAYED START button: the corresponding symbol appears on the display; each time you press the
button, the time (1h,2h, etc up to max 12h) from the start of the selected wash cycle will be increased.
2. Select the cycle and close the door: the timer will begin counting down.
3. Once this time has elapsed, the indicator light switches off and the wash cycle begins.
To adjust the delay time and select a smaller period of time, press the DELAYED START button. To cancel it, press the
button repeatedly until the selected delayed start indicator light switches off. The wash cycle will start automatically
as soon as the door is shut. The Delayed start function cannot be set once a wash cycle has started.

www.sacoapartments.com welcome
Half load option
If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and
detergent. Select the wash cycle and then press the HALF LOAD button: the indicator lights up. If the button is
pressed again, the option will be deselected. Remember to reduce the amount of detergent accordingly.