
IW-EVO6-N23 - related
HDMI Device-related
Navigation(GPS) box - related
You should check the names and colors of each wires exactly, before you connect the wires.
ex) CAN HIGH: White wires / CAN LOW: Blue wires
The ‘POWER / CAN Cable’ should always be connected last and be disconnected rst.
The 'Mode Switch' is an optional part to change modes forcibly without CAN-BUS.
Generally, the CAN-BUS wires are connected for changing modes by original buttons.
When the reverse gear is not detected by CAN-BUS,
the 'REVERSE 12V IN wire’ should be spliced with 1 2V power of reverse light.
Generally, '5V 1A Power output(5V USB POWER)' is a standard voltage for charging smartphone.
If you need higher voltage than 5V, you should add a separate power supply.
HDMI mode accepts general-screen resolution of HDMI devices.
The navigation box should be powered o before unplugging the HDMI cable.
When you connect the power wires(B+, ACC) to the navigation(GPS) box,
the ‘NAVI 12V OUT' wire supported by IW-EVO6-N23 should be spliced with an ACC wire of navigation box.
Precautions