Induro TH-S User manual

TH-S TilTHeaD
Oper aTing inSTrucTiOnS
Thank you for making Induro your choice for
professional photographic gear. Your Induro gear
is manufactured to provide years of dependable
service. In order to obtain optimum satisfaction
and performance we suggest that you carefully
read these instructions and provide them to
anyone who may also use your Induro gear.

Bubble Level
Quick Release Plate
Tilt Lock Knob
Security
Locking Lever
Plate Locking Lever
USER NOTICE
Do not exceed the maximum specied c
load capacity (see Specication chart)
Always ensure that leg and head locks c
are tightly engaged before mounting a
camera on the tripod
Do not use the tripod below c
temperatures of -4°F or above +158°F
(-20°C / +70°C)
Do not leave the product in the sun c
for prolonged periods and avoid high
temperature exposure
For your safety, don’t let your Induro c
tripod come in contact with any
electrical power source
Remove camera, lens, and all gear c
from the tripod when transporting
the tripod
Avoid leaving the tripod unattended c
in areas where people could trip over
the tripod and get hurt
Always clean and dry the tripod after c
it has been exposed to wet, dusty,
sandy or salty conditions. Your tripod
is not recommended for use in salt
water. If required clean tripod using a
mild soap solution applied with a soft
cloth and follow by wiping down with
fresh water. Remove any dust, dirt or
sand from all leg locks, leg lock levers,
leg sections and all moving parts.

OPERATION
1 Install by screwing the head clockwise onto the 3/8" mounting
thread of monopod plate. Once it is hand
tight, secure by fully tightening the
three head locking screws from below.
2 When used properly, the patented dual lock quick release system
offers two levels of security for your
gear. To remove the quick release
plate, squeeze both the Plate Locking
Lever and the Security Locking Lever
and pull the larger locking lever out.
The Quick Release Plate will disengage
allowing it to be removed.
3 To reconnect the Quick Release Plate, insert the angled part
of the plate into the groove on the
opposite side of the locking levers and
press down at. The locking levers
will automatically engage the locking
system and will return to the safety
lock position. Press the Plate Locking
Lever in rmly to secure.
4 Horizontal rotation or panning can be easily accomplished by
swiveling the entire monopod.
5 Front to rear angle or tilt adjustments can be easily
accomplished by rst loosening the
Tilt Lock Knob (be sure to hold rmly
to balance weight of the camera).
Position as desired and tighten the
knob securely.
6 Depending on your requirements, you may nd it convenient to reorient
the camera or lens 90 degrees on the
Quick Release Plate and then remount.
This allows the Tilt Control Knob to give
you different positioning support.

INDURO Camera Support Gear | 8 Westchester Plaza, Elmsford, NY 10523 | T 914-347-3300 | F 914-347-3309 | [e-mail] | indurogear.com
SPECIFICATIONS
CAT # MODEL # CAMERA MOUNT TILT
RANGE
PANNING RANGE
MATCHING MONOPODS
WEIGHT LOAD
LB KG LB KG
Monopod Tilthead TH-Series 484-001 TH-S QR-3D-01-14S* +90°/-90° 360° 0, 1 & 2 0.6 0.3 5.5 2.5 * 1/4-20 Quick Release Plate