Inepro PayMatic AD 2400 User manual

inepro | pondweg 7 | 2153 PK Nieuw-Vennep | The Netherlands | [phone] | [e-mail] | inepro.com
inepro.com
Converting a PayMatic AD2400 from coin acceptor to push button
Instruction
Page 1 of 2
PayMatic AD2400 (-B) -
Convert from coin
acceptor to button
Converting a PayMatic AD2400 from coin acceptor to push button
1. Open the PayMatic and remove the two plugs from the coin acceptor.
2. Cut the plugs off and remove the insulation at the end of the wire.
3. If you are going to twist the wires to connect them (not recommended) remove the JST plug from the
push button assembly. We recommend soldering the wires. In that case remove the wired of the
button assembly completely.

inepro | pondweg 7 | 2153 PK Nieuw-Vennep | The Netherlands | [phone] | [e-mail] | inepro.com
inepro.com
Converting a PayMatic AD2400 from coin acceptor to push button
Instruction
Page 2 of 2
PayMatic AD2400 (-B) -
Convert from coin
acceptor to button
4. The push button should be connected with the two wires of the coin acceptor. Remove the 2 wires of
the push button with the solder iron and solder the 2 wires of the coin acceptor on the pins of the
button. Note: It does not matter which wire is connected to what pin. Of course you should take
measures to prevent the two wires from short-circuiting.
5. Drill a hole with a diameter of 10 mm and mount the push button.
6. To block the coin acceptor entry a screw can be inserted.
7. Now the PayMatic can be closed again and it should be ready for use.