Innovitech X Filter Extension Brackets User manual

X Filter Extension Brackets
The purpose of these brackets is to either extend the X Filter to move it further away from the
sump back or to be used on braced sumps.
Step 1:
Remove and replace the extension
brackets using the same screws already
provided with the X Filter
Step 2:
Loosen the screw on the back of the X Filter
as shown, in order to slide in the extension
spacer
Step 3:
Slide the spacer over the screw from the
notch

Step 4: Secure the spacer by tightening the
screw
Step 5:
Depending on the thickness of the sump
wall, adjust the two screws accordingly in
order to keep the X Filter level.
Note: If the sump wall is thicker than 11mm
(7/16”), the screws can be removed
Step 6:
Position and install the X Filter at the desired
location.
If the sump is braced, the brace will not
interfere with the correct positioning of the
X Filter, as there is clearance between the
brackets and the spacer