INPRO 800 User manual

SECTION VIEW
Safety Glasses, Tape Measure, 3/8” socket for machine screw hex bolt, 7/16” socket for wood screw
hex bolt Level, Power Drill, Drill Bits - 1/4” masonry (concrete/concrete block), Power Miter Saw, 1O”
Blade with 60-80 Carbide Tipped Teeth
Recommended tools
Important
1. Acclimate materials 24 hrs
before installation. Maintain
temperature controlled
environment after installation
2. Install in accordance with
manufacturer’s installation
instructions. Failure to do so
will void the warranty.
Installation tips
1. Cut covers up to 1/16” (1.6mm)
longer to ensure a tight  t.
2. Lubricate blades when cutting
aluminum to reduce burrs.
IPC.321_REV 14
Installation Instructions
800/800W/855/G2-800 Handrails
Please read all instructions
before installing handrail.

Components and fasteners
Installation Instructions
800/800W/855/G2-800 Handrails
Please read all instructions
before installing handrail.

Layout view
Installation Instructions
800/800W/855/G2-800 Handrails
Please read all instructions
before installing handrail.

Exploded view assembly
Installation Instructions
800/800W/855/G2-800 Handrails
Please read all instructions
before installing handrail.

1. Cut aluminum retainer to desired length,
leaving allowance for returns, outside
corners and inside corners. See Figure 1.
2. Drill holes in centerline of aluminum retainer
for brackets, returns, corners and splices
using 1/4" (6mm) drill bit. Position aluminum
retainer against wall at desired height
allowing for returns and corners. Level and
mark bracket holes on wall. Drill marked
holes with 3/4" (19mm) drill bit for toggle
bolts (drywall installation) or 1/2" (13mm)
drill bit for lead anchor (concrete wall
installation). See Figure 2.
FIG. 2
FIG. 1
Installation Instructions
800/800W/855/G2-800 Handrails
Please read all instructions
before installing handrail.

FIG. 3
FIG. 4
3. Attach returns and corners to retainer
leaving a 1/16" (1.5mm)gap between
returns/ corners and retainer to allow for
adjustment. Loosely attach brackets to
retainer. Mount on wall, level retainer
and tighten screws to secure.
See Figure 3.
3a. For long runs of handrail, secure each
section of aluminum retainer to the next
with the supplied splice piece.
NOTE: Make sure you install the splice
with side "A" facing out.
4. Cut cover to length between returns
and/or corners. (Note: Distinct top and
bottom for cover. Trim factory edges
square before installation). Position
cover on retainer and adjust returns
and/or corners for a tight fit. Snap
cover on retainer by starting at top and
pivoting over the bottom of retainer.
See Figure 4.
Note: For 855 Covers Only – When
continuous runs are over 12' (3m),
covers should be installed in
consecutive order using the numbers
found on the back of covers. This
ensures proper alignment of accent
strip.
Installation Instructions
800/800W/855/G2-800 Handrails
Please read all instructions
before installing handrail.