Flat size (W×H): 7.09 × 7.48 in. (180 × 190 mm)
Final folded size: 2.35 × 3.74 in. (60 × 95 mm)
PACKAGE CONTENTS
• Refrigerator water lter
• Quick Setup Guide
COMPATIBILITY
Works with LG®and Kenmore®
refrigerator models: LMXS30796S,
LMXS30796D, LMXC23796S, LMXC23796D,
LFXS30796S, LFXS30796D, LMXS28626D,
LFXC24796D, LFXC24796S, LSXC22396S,
LSXS26396S, LSFXC2496D, LSXC22396D,
LMXS28626S, LFXS28968, LMXS28626,
LFXS28566, LMXS28636, LFXS28968S,
LFXS28566M, LMXS28636S, LFXS28968D,
LFXS28566S, LFXS28566D, LSFXC2496S,
LFXC22596S, LFXS26596M, LFXS28596D,
LFXS26566M, LFXS26973D, LFCC22426S,
LFXC22526S, LFCS28768S, LSXS26336S,
LFXS26566S, LFXS26973S, LFXS26596S,
LFXS28596M, LFXS28596S, LMXC23796M,
and LFXS27466S
Upper corner lter:
2To open the lter cover, push in
where indicated and the cover will
drop down.
3Remove the old lter by slowly
rotating it counterclockwise. A
small amount of water may drip
down.
4Insert the new lter into the water
lter holder.
5Slowly turn the new lter clockwise
until it stops. The lter will click and
lock into place.
6Close the lter cover.
FEATURES
• NSF 42 and 53 certied to remove contaminants, including chlorine, cysts, lead,
mercury, carbofuran, benzene, and endrin
• Lasts up to six months or 200 gallons (757 L)
• Eliminates cloudiness for fresh, clear drinking water
INSTALLING YOUR WATER FILTER
1Shut o the water supply, then turn o the water shuto valve on your
refrigerator. Locate the lter holder in your refrigerator.
Before using your new product,
please read these instructions to prevent any damage.
QUICK SETUP GUIDE
Refrigerator
Filter
NS-LGLT1000P531
Side door lter:
2Lift up and remove the lower bin
door.
3Swing the right end of the old
lter out of the compartment
and then hold and rotate the
lter counterclockwise to
remove it from the lter head.
4Insert the new lter into the
lter head and rotate it
clockwise.
5 Swing the lter back into the
compartment.
6Replace the lower bin door.
7 Turn on the the water supply and run water through the dispenser for about ve
minutes at 0.5 gpm (about 2.5 gallons or 9.5 L) to remove any trapped air and clear
the system.
CAUTION: This lter should not be used with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
8Open the refrigerator door and make sure that no water leaks from the new lter.
Note: If leaks occur, repeat the installation steps. If leaks persist, discontinue use and call
customer service.
WARNING: To reduce the risk of property damage due to water leakage, this lter MUST be
installed in accordance with the manufacturer's specications and instructions. This lter unit
must be replaced every 200 gallons (757 L) or six months. Failure to follow instructions and
operating specications will void your warranty. Further, manufacturer assumes no
responsibility or liability for damages arising out of misuse of the product.
RESETTING YOUR CHANGE FILTER INDICATOR
• LG: Press and hold the reset button for three seconds. If this doesn’t work, see the
documentation that came with your refrigerator.
• Kenmore: The lter reset for Kenmore refrigerators varies by model. See the
documentation that came with your refrigerator.
OR
NS-LGLT1000P531_20-0289_QSG_V1_EN.ai 1 7/15/2020 8:37:15 AMNS-LGLT1000P531_20-0289_QSG_V1_EN.ai 1 7/15/2020 8:37:15 AM
