INSTEON 74551 User manual

INSTEON Garage Door Control Kit
74551
Quick Start Guide

ALWAYS ON
INSTEON Garage Door Control Kit
On/Off
Set Button
Status LED
Always On
Outlet
Magnet Spacer (2x) Motor WireDoor Sensor

!
Motor Wire
Multi-Function Wired Remotes
If your garage door system uses a multi-
function wired remote, contact your
manufacturer about using a dry-contact
switch.
X
Exercise Caution
Only remotely close a garage
door when it is safe. Add an
INSTEON IP Camera or IR beam
device to enhance safety.
NEW
X

1Close your garage door and disconnect
the garage door opener from power.
Installation
NEW
X
REMOTE
ALWAYSON

NEW
X
If wires are already connected to the
terminals, add the I/O Linc wires.
2Connect the bare wires leading from
the I/O Linc to the garage door motor
terminals.
REMOTE
ALWAYSON
REMOTE
!

3Mount the magnet to the door and the
sensor to the door frame. The best
location is centered, near the opener
rail. If necessary, use spacers to adjust
sensor height.
Up to ½”

REMOTE
ALWAYSON
4
5
Route and secure the sensor wires along
the opener rail back to the motor. Plug
the I/O Linc and garage door motor into
power.
Test the Garage Door Kit by tapping the
set button on the I/O Linc module.
NEW
X
NEW
X

REMOTE
ALWAYSON
NEW
X
NEW
X

1Follow the on-screen instructions to add
the I/O Linc to your INSTEON Hub.
Linking to the Hub
If not using the Hub, refer to the
instructions that came with your product.
NEW
X
+

RAW-1302 Rev 06.04.13
Protected under U.S. and foreign patents (see www.insteon.com/patents)
Portégé par des brevets américains et étrangers (consultez www.insteon.com/patents)
©2013 INSTEON
2When prompted, press and hold the set
button on the I/O Linc.
NEW
X
For the complete Owner’s Manual and
more, visit: insteon.com/support
MANUAL
ALWAYS ON