Inter-lux linea light i-LED SUELO-R 8W User manual

Revisione: - Data di creazione :27/11/2015 - Data ultima modifica : 27/11/2015 Pag. 1
INSTALLATION INSTRUCTIONS
LED-FGI369-E
CONCRETE
OUTERCASING
COD. E98121
DRAINAGE LAYER
MIN 7,87" - 11,81"
GROUND
O0,9"
OK
CURROGATED
PIPE
SCREWS
INCLUDED
SECONDARY CABLE
INCLUDED
TOOL NOT
INCLUDED
20°
20°
A
UNSCREW SLIGHTLY THE SCREW
TO FACILITATE TILTING
AA
TIGHTEN THE SCREW
A
UNSCREW THE FLANGE AND
REMOVE THE GLASS
ADJUST THE TILTING
12
345
ADJUST THE TILTING
SUELO-R 8W // SUELO-Q 8W
SUELO-RJ 8W // SUELO-QJ 8W

Pag. 2
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
MOUNTING INSTRUCTIONS
READ ALL OF THESE INSTRUCTIONS BEFORE INSTALLING FIXTURES
· Keep all of the instructions for future reference
· Turn off power before installing fixture
· Installation is to be performed by a qualified electrician only
· All installations must conform to the National Electrical Code as well as all local jurisdictional codes and regulations
· Any modification of the luminaire will void any and all written or implied warranties
· The manufacture accepts no responsibility for damage to persons or property airing through improper use or installation
B
B
SECTION B-B
4,3"
6,1"
0,9"
2,7"
O0,9"
INSERT THE GLASS AND TIGHTEN
THE FLANGE
6OUTERCASING COD.E98121
Colours Secondary Cable Pole
Wire black number 1 +
Wire black number 2 -
Wire green Ground
INSTALLATION SEQUENCE
- Mount remote driver in accessible well ventilated space
- Ensure power is off before connecting driver to line voltage
- Fix the outercasing on the ground, the surface must be perfectly flat
- Connect secondary wiring to fixture wiring
- Insert the Suelo into the outercasing and fix it with the screws [1]
- WARNING - Be sure secondary wiring is connected to driver BEFORE energizing to avoid LED failure
- Energize
SEQUENCE FOR ADJUST TILTING
- Ensure power is off before opening the Suelo
- Unscrew the flange and remove the glass [2]*
- Unscrew slightly the screw to facilitate tilting [3]
- Adjust the tilting [4]
- Tighten the screw [5]
- Insert the glass and tighten the flange [6]**
- Energize
* Only for Suelo Stainless Steel finish, unscrew the ring, remove the flange and the glass
** Only for Suelo Stainless Steel finish, insert the glass, insert the flange and tighten the ring