
NLM-8000A
Local achine
4. PHANTOM POWER INDICATOR LED
It is a indicator for status of phantom power. Red
LED is on, when phantom power is turn on.
5. PHANTOM POWER SWITCH
It is a phantom power switch to supply power (+15V)
for condenser mic.
Rear Panel
Features
This is the analogue audio input wall mounted for R-
8000 installed on NPX-8000. It not only broadcast a local
area, but also every area by L & R line input and micro-
phone input.
Front Panel
L R
LINE
MIC
GAIN
PHANTOM
+16 +50
1. LINE INPUT(RCA) CONNECTORS
It is RCA connectors. Refer to blow figure for suitable
cable.
2. MIC GAIN ADJUST KNOB
It is knob for adjusting mic input gain (+16dB ~
+50dB)
3. MIC INPUT( LR) CONNECTOR
This is a XLR connector for microphone input. Use
balanced cable. Refer to below figure for using un-
balanced cable.
1. LINK IN PORT
It is a connector for supplying power, communica-
tion, audio line. Connect previous devices to extend
system.
※ Use only direct cable to link with each devices.
※It is recommended CAT 5E DCR with less than
9.8 Ω/100m.
2. LINK OUT PORT
It is a connector for communication line. When ex-
tend system, It can supply power to next device.
NO Description
1 CAN – H
2 CAN - L-
3 N.C
4 DC 40V
5 GND
6 N.C
7 Audio Out+
8 Audio Out-
< RJ 45 Pin Description >