International Light Technologies ILT 950 User manual

Installation Guide for the ILT 950
Below is a picture of the 950 as it arrives in the case. Please identify the items shown below.
SpectriLight
III D
950 Spectro-
Radiometer
Detector
Head
USB able and Optical Fiber
Tripod

Please note that the detector head and the optical fiber are fragile and subject to damage if
they are not handled properly.
Detector head handling:
•Whenever the detector head is not in use, place the plastic cover over the optics.
•Do not touch the optics, as this may degrade the transmission and affect the calibration.
•If the optics do get dirty, use optical cleaning processes compatible with precision optics.
•Whenever the detector head is not attached to the optical fiber, cover the port with the
black plastic cover provided for shipping.
Optical iber Handling
•Whenever the fiber is not in use, place the plastic covers over the ends.
•Do not touch the ends of the fiber, as this may degrade the transmission and affect the
calibration.
•If the optics do get dirty, use optical cleaning processes compatible with precision optics.
•In order to avoid permanent damage to the fiber, do not bend the fiber to a radius >
25mm.
Getting the 950 ready for operation
1. Mount the detector head to the tripod or other convenient structure using the ¼-20 tapped
hole.
2. Remove the plastic cover and mount the optical fiber to the back of the detector head.
3. onnect the other end of the optical fiber to the 950.
4. onnect the USB cable to the front of the 950.

5. Install the SpectriLight D into a computer, and follow the installation instructions.
6. onnect the USB cable to the computer, and check that the green “Power” LED is lit.
7. When the unit is collecting data, the yellow “Scan” LED will light.
=====================
International Light Technologies
10 Technology Drive
Peabody, MA 01960
USA
Phone: [phone]
Fax: [phone]
Email: [email protected]
Web: www.intl-lighttech.com
Power LED
Scan LED