Intersurgical 7000 Series User manual

Intersurgical
7000 Series Respiratory Humidifier
1Power Switch
2Temperature Display
3Mode Change
4Mode Display LED’s
5Scroll Buttons
6Set Temperature Button
7Status Indicator LED’s
8Alarm Silence Button
MODE
SET
!
° C
MANUALAUTO
ALM
T emp
C onnection
1
2
3
4
7
5
6
8
Turn on Humidifier by briefly pressing power switch (1) Unit will default to last mode
used.
Select desired mode by holding down Mode Button (3) repeat until desired mode is
selected.
IPPV Mode: This mode is preset for intubated patients. The temperature for the
patient side is controlled to 40°C and chamber side to 37°C.
NPPV Mode: This mode is preset for patients using a NIV (Non Invasive Ven-
tilation) interface. The temperature for the patient side is controlled to 34°C and
chamber side to 31°C.
MANUAL mode: This mode allows the selection of temperatures for patient side and
chamber side.
The set values can be changed by following the instructions in Section 5.3.4 of the Instruc-
tions For Use.
Temperature Display (2). The display shows either chamber outlet temperature or
patient temperature (whichever is selected as default). To display the alternate measured
temperature, hold down the alarm silence button (8) for 2 seconds, the display will then
revert after 10 seconds.
Alarms. An audible alarm will sound. A status indicator LED (7) on the front panel will
highlight the location of the fault. The audible alarm can be muted for 2 minutes by pressing
the alarm silence button (8).
If an Alarm state is left unresolved for 10 minutes, the humidifier will enter stand-by, with the
display showing “000”. Switch humidifier off and on to exit stand-by.

SUG7000 issue 1 03.13
Expiratory limb heated
wire connector
Airway temperature
probe
Chamber
temperature
probe
Mains lead
Heated
wire
adaptor
Dual temperature
probe connector
Inspiratory limb heated
wire connector
Mount Humidifier Heater Base. Mount the heater base using an appropriate bracket;
ensure the top of the humidifier chamber is placed lower than patient airway entry position.
Mount humidifier chamber onto humidifier base. Ensure chamber clicks into place.
Connect patient circuit to chamber. See example below.
Add water to humidifier chamber. Follow chamber manufacturers guidelines.
Heated Wire. Ensuring that the white arrows on both connectors are aligned, connect the
appropriate heated wire electrical adaptor to the Black/Yellow Push-Fit connector on heater
base. Connect the cloverleaf connector to the inspiratory heated wire limb; if using a Dual
Heated Circuit, connect oval connector to the expiratory heated limb connector.
Dual Temperature Probe. Ensuring that the white lines on both connectors are aligned,
connect the dual temperature probe to the Green/Silver Push-Fit connector on heater base.
Then insert the temperature sensors in to their appropriate ports on the inspiratory limb, as
shown in diagram below.
Connect power cord to AC wall socket
Turn on gas supply equipment (Ventilator). Connect the ventilator to the gas supply
and turn on and carry out pressure (tightness) testing applicable to that ventilators protocol.
Expiratory limb
Water Bag Spike
Exp
Insp
Inspiratory limb
Important: This guide is not intended to replace the Instructions for Use. It is the users
responsibility to ensure the device is operated correctly and in accordance with the Instruc-
tions for Use.