Intrasonic Technology RETRO MYDOOR User manual

RETRO
MYDOOR
INSTALLATION
INSTRUCTIONS
Intrasonic Technology, Inc. – 9525 Forest View Street, Dallas Texas – 877-435-0670
www.intrasonictechnology.com

1
RETRO MYDOOR™
INSTALLATION
1. Ensure that the door has been powered on and connected to the home Wi-Fi before
installation*
Refer to the Operation Manual for the initial Wi-Fi setup instructions.
*INSERT MICRO SD CARD PRIOR TO INSTALLATION OF THE DOOR UNIT*

2
2. Now is also a good time to position the door unit where it’s going to be installed so you
know the angle at which the camera needs to be adjusted.
The camera is in a ball joint-like housing. You can physically pivot the camera’s viewing
angle to a desired direction (see images below for reference).
3. There are two (2 conductor) cables coming out of the back of the included adapter
bracket. Make sure these are routed through the bracket opening before installation.

3
- Bracket (wiring) Attachment to Door Unit -
***You will also see this cable/connector coming through the included adapter
bracket (pictured above).
Pre-installation, you will want to route this cable through the rain guard first (1) –
then connect it to the back of the door station (2).

4
4. The adapter bracket will need to be connected back to the RETRO master station via
three wires – the same way every other station is connected.
The labeling on the adapter bracket’s terminal is different than what you’ll see on the
master station’s connections, but the values are the same.
Compare the images below for reference.
V+ (Adapter Bracket) +15V (RETRO Master – Door 1/2 terminal)
G(Adapter Bracket) 0V (RETRO Master – Door 1/2 terminal)
L(Adapter Bracket) LINK (RETRO Master – Door 1/2 terminal)

5
5. With all of the other wiring routed through the opening of the bracket and the RETRO
system’s wiring connected to the back of the bracket, position it appropriately and
adhere it to the wall/housing.
6. The aforementioned (2-two conductor) cables coming off of the back of the bracket
(which should now be routed through the bracket) must also be routed through the
opening of the rain guard and connected to the back of the door unit as such_

6
7. With the rest of wiring routed through the opening of the rain guard, position the guard
on the wall accordingly.
We also advise applying some sort of caulk to the top and sides of the guard AND
adapter bracket (bottom open) for added weather protection*
The station is weather resistant – NOT weather proof!
8. The MyDoor™ must then be screwed to the adapter bracket – securing the rain guard in
place behind it.

7
9. Lastly, position the faceplate over the MyDoor™ and secure it in place with the included
bolts.

8
CONNECTORS
1. Connection from Adapter Bracket_
This will be one of the two connectors tethering the adapter bracket to the door station
itself.

9
2. Lock #2 Relay_
You can connect up to two locks/strikes.
The pin layout for relay #2 is as below_
EXAMPLE: