INVENTOR INVMS45A User manual

Refrigerator - Freezer
User’s Manual
English
Thank you for choosing INVENTOR
refrigerator-freezer. For correct use of
this unit, please read this manual
carefully and keep it for future
reference.
INVMS45A
E
L
E
C
T
R
I
C
A
P
P
L
I
A
N
C
E
S

1
General
This appliance is intended to be used in
household and similar applications such as
– staff kitchen areas in shops, offices and
other working environments;
– farm houses and by clients in hotels,
motels and other residential type
environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.
This type of refrigerator is widely used in places
such as hotels ,offices, student dormitories and
houses. It is mostly suitable for refrigerating and
preserving foods such as fruits and beverage. It
enjoys the advantages of small size, Lightweight,
Low electric consumption and easy use.

2
Instructions for Installation
1.Do not tilt the refrigerator for more than 450
form upright during moving it. And do not apply
force on any part such as condenser and door to
prevent the refrigerator from deforming, or else
it will influence its performance.
2.Let the refrigerator have enough space to work
well.
3.Don’t install it in high temperature of humidity
place so as to avoid being damaged, dampened
and rusted.
Cautions for Safety
1.Before the refrigerator is plugged in chech in the
electric voltage to be used fit is the same as the
rated voltage. The power plug should have its
independent socket, adapter may cause the
socket overheat.
2.Don’t store inflammable materials such as ether,
benzine, LP gas and glue etc in the refrigerator.
3.Don’t splash water on the refrigerator, it may
arouse malfunction or electric shock.
4.When gas leaks from its container. Don’t pull the
plug out or in. it may arose sparks and fire
calamities.
5. This appliance is not intended for use by

3
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
6. Children should be supervised to ensure
that they do not play with the appliance.
7. If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
8.Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of

4
obstruction.
9. Do not use mechanical devices or other
means to accelerate the defrosting process,
other than those recommended by the
manufacturer.
10.Do not damage the refrigerant circuit.
11. Do not use electrical appliances inside
the food storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer.
12. Do not store explosive substances such
as aerosol cans with a flammable propellant
in this appliance.

5
Disposal
1. Old appliances still have some residual
value. An environmentally friendly method of
disposal will ensure that valuable raw
materials can be recovered and used again.
2. The refrigerant used in your appliance and
insulation materials require special disposal
procedures. Ensure that none of the pipes on
the back of the appliance are damaged prior
to disposal. Up to date information
concerning options for disposing of your old
appliance and packaging from the new one
can be obtained from your local council
office.

6
Instructions for Use
1.When operating the refrigerator for the first time,
run it without loading any food until it autos
tops at the desired temperature. Usually it takes
2 or 3hours,then set the thermostatic dial at the
setting desired and put foods in the refrigerator.
2.The temperature of the refrigerator can be
adjusted by turning the thermostatic dial. A
medium setting of the thermostatic dial is the
most suitable for general operation.
3.Defrost the freezing compartment whenever the
layer of frost on the surface of the evaporator
reaches 3 or 4 mm. When defrosting remove all
food and set the thermostat at “OFF” position.
Put the drip tray under the evaporator to collect
melted water. After the frost has melted, discard
the melted water and dry up the interior of
refrigerator. The refrigerator can then be
restarted by turning its thermostat to the desired
setting.

7
Cautions for Use
1.The more foods tuff put in or the more and the
longer for once the door is opened, the more it
needs electric consumption, which even leads
malfunction.
2.Better not to place the objects which are too
heavy ,pointed or corrosion on table board.
3.Re-plugging in the power plug at the interval of
over ten minutes.
4.Don’t store bottled drink in the freezer, so as to
prevent from being broken and damaging the
refrigerator.
5.Open the door as less as possible during
power-cut.
6.When defrosting, never use any sharp or metallic
objects to remove the frost on the surface of the
evaporator as it will damage the evaporator.
7.Don’t touch foods and containers in the freezing
compartment with your wet hands so as to
prevent from being frostbitten.
Maintenance
1.While cleaning the refrigerator. pull out the
electric power plug, rub carefully with a piece of
cloth soaked with natural cleanser then wipe
with clean water. The abrasive cleaning power,
alkali cleansers, chemical cloth, thinner, alcohol,
acid petroleum product and hot water are not

8
suitable for cleaning the refrigerator, they may
damage the painting cover and plastics.
2.The door gasket is dirty and fogged easily, so
clean it frequently.
3.If the refrigerator is out of use for a long time,
please pull out the plug, clean and dry the
freezing compartment then close the door
tightly.
The following cases are not malfunction
1.A flowing water sound:
Flowing water sound will be heard under normal
operation.
2.Outside condensation:
Outside condensation is normal in high humidity
condition. You may just wipe it up yourself.
3.It takes some times for the temperature of the
freezer and refrigerator compartments to become
cold after the refrigerator starts to operate: If the
temperature of the two compartments is higher
while the refrigerator is operating, it takes some
times for the temperature of the two
compartments to become cold. If the
environmental temperature is higher, it takes a
long time to make the compartments to become
cold.
4.The surface of the compressor becomes hot:
The surface of the compressor may become hot
under normal operation. Don’t touch it with

9
hands.
Methods of inspecting malfunction
If any case of malfunction happens, please
inspect and dispel it according to the methods
shown in the following table.
case Inspection
Not
refrigerating
Is there no electric current?
Is the voltage normal or not?
Has the socket fused?
Has the plug been put in
effectively?
Not efficient
Is the thermostatic dial set to the
correct position?
Is there any suitable clearance
surrounding the refrigerator?
Has the door been opened too
frequently or too long?
Is the refrigerator exposed to
sunlight directly or placed near
some heating devices.
Are there too much food inside?
Or are too hot?